UTV Series Bed Rail System for 2026 Can-Am Defender HD11

⚠️ IMPORTANT FITMENT NOTICE ▼ This system is designed for the 2026 Can-Am Defender HD11. Confirm your model year before ordering. Not sure? Email info@greentouch.com. The side rails have side-drilled holes, so the required EE082 Mounting Brackets are needed to mount any Green Touch rack. EE082 brackets and racks are sold separately. What's in the Box/Kit: ▼ + (2) SIDE RAILS: 41-5/8" square-tube side rail bars, side drilled. + (1) CROSS BAR: 57" front cross bar with welded corner plates. + (6) CLAMPS: Bed lip clamps. + (12) SPACERS: Leveling spacers (upper blocks and lower spacers). + (2) CAPS: Square plastic tube end caps. + (14) SETS: Hex bolts, nyloc nuts and washers. Bed rail system for the 2026 Can-Am Defender HD11. This bolt-on rail system fits the bed of the 2026 Can-Am Defender HD11 and gives you a mounting platform for Green Touch racks. Two side rails and a front cross bar clamp to the bed lip, so racks sit on a fixed frame. Racks and the required EE082 mounting brackets are sold separately. KEY BENEFITS: — BOLT-ON INSTALLATION: Clamps under the bed lip and bolts together, with no welding. — OPEN BED FLOOR: Racks ride on the rails, not the bed floor, so the full bed stays open for gear. — MOUNTS GREEN TOUCH RACKS: Add trimmer racks, blower racks, a sprayer cage or other Green Touch racks with EE082 brackets. — HARDWARE INCLUDED: Clamps, leveling spacers, end caps and fasteners come in the kit. Fits the 2026 Defender HD11 Built for the bed of the 2026 Can-Am Defender HD11. The front cross bar sits against the cab bulkhead on welded corner plates. Add racks with EE082 brackets Each EE082 slides over the rail and creates the top-facing holes a rack bolts into. Plan on one EE082 for a single rack or cage such as the BPS100, SPC21 or TBX100, and two for a trimmer rack such as the XA102, XB103 or XC104. Racks, trimmers and accessories shown are sold separately and are not included. Welding, drilling or modifying this product is not covered by the 6-month limited warranty. Install and torque all fasteners per the instruction sheet and re-check them before use. Do not exceed your vehicle manufacturer's bed load rating. Aftermarket mounting may affect your vehicle warranty. Can-Am, Defender and HD11 are trademarks of BRP Inc.; Husqvarna is a trademark of its owner. Green Touch Industries is not affiliated with or endorsed by either. Names are used only to identify compatible products.