CTX Cordura 1000D Grip Kit for Magpul SGA — Mossberg 500/590

Laser-cut Cordura® 1000D panels for the grip section of the Magpul SGA stock. Adheres to the polymer — nothing is removed, nothing is permanent, and it comes off clean whenever you want it off. Fits: Magpul SGA stock fitted to Mossberg 500, 590, 590A1 and Maverick 88. This is the grip section only. The stock body is a separate kit and the Magpul forend is a third — same fabric, so all three can be ordered in one colorway. A pump gun is the one long gun where both hands are doing real work under load, and the firing hand is the one holding on while the support hand cycles the action. The SGA grip is smooth polymer with a shallow moulded texture, which is fine dry and does very little in rain, in a blind, or through a glove. Fabric gives the hand something to key into instead. The SGA arrives as one moulded piece, and we cut it as two kits on purpose. The grip and the comb see completely different wear, and plenty of people only want one of the two done. Order both if you want the whole stock covered. Cordura® 1000D, MIL-DTL-32439 compliant. IR compliant and Berry compliant. 3M Low Surface Energy adhesive. Grips mechanically rather than bonding chemically to the polymer, so it lifts off clean and takes the adhesive with it. No gunsmithing. Nothing is drilled, sanded or refinished, and the stock does not have to come off the gun. Installs in minutes. Alcohol wipe, peel, place, press. A 20-minute window to lift and reposition before the adhesive sets. Cut and made in Pennsylvania. Wrap only — the stock and firearm are not included.