Fluorocarbon Fly Fishing Tippet 50m Spools

Pure fluorocarbon tippet on 50m spools, in four diameters from 0.15mm to 0.28mm. Fluorocarbon has a refractive index close to that of water, so in clear, pressured water it is as close to invisible as tippet material gets. If fish are following and refusing, or you are getting far fewer takes than the angler next to you, the tippet is usually the reason. This is the fix. Why fluorocarbon? Near invisible in water. A refractive index of roughly 1.42 against water's 1.33 means light passes through it rather than reflecting off it. Nylon sits noticeably higher. On flat, calm water and to educated fish, this is the single biggest difference you can make. Sinks, and sinks quickly. Denser than water, fluorocarbon cuts through the surface film instead of sitting in it. Your nymphs get down faster, and there is no shiny line shadow lying across the surface above a dry. Exceptional abrasion resistance. The hard outer surface shrugs off contact with rocks, teeth, and gravel far better than nylon. Fish it around structure and snags with confidence. No water absorption. Nylon absorbs water and can lose a significant portion of its strength when wet. Fluorocarbon absorbs virtually none, so the breaking strain on the spool is the breaking strain on the water — first cast or last. Low stretch. More direct contact with your flies, sharper takes registered, and faster, more positive hook sets — especially at range or when nymphing deep. UV resistant. Unlike nylon, fluorocarbon does not degrade in sunlight, so a spool keeps its strength season after season. When to fish it Fluorocarbon is the first choice for nymphs, lures, buzzers, and wet flies — anything fished in or under the surface. Its fast sink rate and invisibility make it ideal for clear rivers, hard-fished stillwaters, and bright, calm days when fish have every chance to inspect your leader. For dry fly work, grease the tippet or leave the last few inches ungreased so the fly sits naturally while the tippet hangs just under the film, out of sight. Choosing your diameter Diameter Breaking strain Best for 0.15mm 2lb Small wets and light nymphs, sizes 16–22, spooky fish in low, clear water 0.24mm 8lb Stillwater buzzers, lures, and washing-line rigs; all-round stillwater point 0.26mm 10lb Bigger lures and boobies, boat fishing, snag-heavy water 0.28mm 12lb Streamers, pike-fry patterns, and maximum-strength points Knots and handling Fluorocarbon is stiffer and harder than nylon, so knot technique matters. Always wet the knot before drawing it down slowly, and seat it fully — a properly tied five-turn grinner (uni) or three-turn water knot for droppers will hold at close to full line strength. For tippet rings and fly attachment, a Davy knot or non-slip loop keeps small flies moving naturally. 50m spools Each spool carries 50 metres — roughly double a standard tippet spool — so you get more days on the water per spool and a lower cost per metre. The compact spool fits any tippet caddy or vest pocket. Please dispose of waste tippet responsibly: fluorocarbon does not biodegrade, so take offcuts home with you. Specifications Material 100% fluorocarbon (PVDF) Spool length 50 metres Diameters 0.15mm / 0.24mm / 0.26mm / 0.28mm Breaking strains 2lb / 8lb / 10lb / 12lb Finish Matt grey — low flash, low visibility Sink rate Fast — denser than water, cuts the surface film Water absorption Virtually none — full rated strength when wet Stretch Low — direct contact and positive hook sets UV resistance High — no degradation in sunlight Best suited to Nymphs, buzzers, lures, and wets in clear or pressured water; freshwater and saltwater safe