Acura TLX Rear Taillight Tint Overlay 2021+

Easy Install These overlays cover the clear part of the taillight only. Set of 2 rear taillight tint overlays Upgrade the look of your Acura without breaking the bank. Instead of spending on expensive taillight replacements or paint, Vinyl Flare’s premium pre cut taillight tint overlays offer a clean, modern finish with an easy DIY install. Designed to give your rear end a sleek smoked look, these overlays add a stealthy touch that instantly elevates your build. Each piece is precision cut to match the shape of your taillight, making installation smooth, clean, and stress free with no trimming required. Product Highlights • Smoked tinted film designed specifically for rear taillight overlays • Pressure activated adhesive for easy positioning and adjustment • Durable material with a 9 year expected life span • Available in multiple shades and transparency levels • Best suited for flat or slightly curved taillight surfaces Installation Instructions Step 1: Surface Prep • Clean the taillights thoroughly with mild soap and water, then dry with a lint free cloth • Use isopropyl alcohol to remove any grease, wax, or residue • Recommended installation temperature is 50°F to 77°F for best adhesion Dry Application Method Step 2: Positioning Align the pre cut overlay with your Acura taillight Use small pieces of masking tape to hold it in place and test fit before applying Step 3: Apply Overlay Peel the backing carefully without stretching the vinyl Apply from one side while smoothing it down with a squeegee or microfiber covered finger Press firmly to remove any air pockets Step 4: Heat and Seal Gently warm the overlay with a heat gun or blow dryer to soften the film Work the edges and any curves for a tight finished look Smooth out any remaining bubbles with light pressure Wet Application Method Step 2: Make Application Fluid • Mix a few drops of dish soap into a spray bottle of water • Lightly mist both the taillight surface and adhesive side of the overlay Step 3: Position Overlay Peel the backing and lightly spray the adhesive side Place the overlay onto the taillight and adjust as needed Step 4: Apply and Set Use a squeegee to push water and air out from the center outward Continue smoothing until the overlay sits secure and flush Step 5: Final Seal Let the overlay sit for 15 to 20 minutes Gently warm it to activate the adhesive and help finalize the bond Press down all edges for a clean finished install