Nano PCA9685 Joystick Kit with 2 MG90S Servos

Develop joystick-controlled motion with a Nano ATmega328P, PCA9685 servo driver and two MG90S metal-gear micro servos. Your firmware reads the KY-023 joystick's X/Y inputs and commands the servos for small robotic mechanisms, interactive projects or a pan-tilt build using your own brackets. The pre-soldered Nano has CH340C and USB-C, and the pre-soldered PCA9685 connects over I2C. A 400-point breadboard and 10cm jumpers are included for prototyping. A regulated external servo power supply is required and not included; share ground with the controller and never power servos from GPIO.Bundle value: Purchased separately, the included component variants total $45.69. This kit is $37.99, saving $7.70. 1 × pre-soldered ATmega328P Nano board with CH340C and USB-C 1 × pre-soldered PCA9685 16-channel PWM servo driver 2 × MG90S metal-gear 9g micro servos 1 × KY-023 dual-axis analog joystick module 1 × 400-point solderless breadboard 1 × 120-piece, 10cm jumper wire set A regulated external servo power supply is required and not included; share ground with the controller. Assembly and your own firmware are required. USB-C data cable, computer, mechanical brackets and enclosure are not included. Do not power the servos from a controller GPIO pin.Read the kit setup guide for assembly planning, required extras and component references.