Genuine Bosch 89lb/hr 1000cc Fuel Injectors Short Style Extended Tip (Set of 4)

Bosch 1000cc High Impedance Fuel Injectors – EV14L 65mm Genuine Bosch Motorsport 1000cc high-impedance fuel injectors designed for high-performance naturally aspirated, turbocharged, and supercharged applications. These injectors utilize Bosch EV14 technology to provide consistent fuel delivery, precise atomization, and fast response times across a wide operating range. Each injector features a compact EV14 body fitted with height adapters to achieve the standard 65mm EV14L configuration, measured center-to-center between the O-rings. A filtered top adapter is included to provide additional protection against fuel system contaminants. These injectors are suitable for gasoline and E85 applications and feature a 12-ohm high-impedance coil, EV1 electrical connector, and extended-tip nozzle with a single-cone spray pattern. Their 65mm configuration allows installation in fuel rails designed for standard EV14L injectors. Features: Genuine Bosch Motorsport fuel injectors 1000cc nominal flow class High-impedance, 12-ohm design Bosch EV14 injector technology 65mm EV14L configuration with installed height adapters Filtered top adapter Extended-tip nozzle with single-cone spray pattern Compatible with gasoline and E85 Suitable for naturally aspirated and forced-induction applications Specifications: Injector Type: Bosch EV14 Flow Rating: 1000cc Class (980cc/min nominal at 3 Bar) Length Without Adapters: 39mm (EV14K) Length With Adapters: 65mm (EV14L) Connector: Bosch EV1 / Jetronic / Minitimer O-Rings: 14mm Top / 14mm Bottom (Viton) Resistance: 12 Ohms Nozzle: Extended Tip Spray Pattern: Single Cone Fuel Compatibility: Gasoline, E85, Methanol* Static Flow Rates: 2.0 Bar (29 PSI): 720 cc/min – 69 lb/hr 3.0 Bar (43.5 PSI): 900 cc/min – 86 lb/hr 4.0 Bar (58 PSI): 1038 cc/min – 99 lb/hr 5.0 Bar (72.5 PSI): 1170 cc/min – 111 lb/hr 6.0 Bar (87 PSI): 1284 cc/min – 122 lb/hr 7.0 Bar (101.5 PSI): 1344 cc/min – 128 lb/hr Estimated Horsepower Capacity: Estimated horsepower support based on a 10% fueling safety margin. Actual capacity will vary depending on fuel pressure, injector duty cycle, engine efficiency, and fuel consumption. Engine Gasoline Turbo Gasoline N/A E85 Turbo E85 N/A 4-Cylinder 516 HP 672 HP 448 HP 560 HP 5-Cylinder 645 HP 840 HP 560 HP 700 HP 6-Cylinder 774 HP 1008 HP 672 HP 840 HP 8-Cylinder 1032 HP 1344 HP 896 HP 1120 HP Installation Notes: ECU tuning is required when installing higher-flow injectors. Injector scaling, dead time, and fuel pressure compensation must be configured for the application. Verify fuel rail dimensions, injector length, connector type, and O-ring compatibility before ordering. *For methanol applications, flush the injectors with gasoline after use. Methanol should not remain inside the injectors for extended periods. Flow measurements are based on controlled test conditions and may vary with fuel type, temperature, and differential fuel pressure.