Weber Gas Grill Hose & Regulator Kit 67069 — 5FT Replacement for Spirit II, Genesis II & Summit Series

OEM-Compatible Replacement Part Weber Gas Grill Hose & Regulator Kit 67069 — 5FT Replacement for Spirit II, Genesis II & Summit Series Part# 67069 Replaces 69891 5FT Hose Fits Weber Spirit II Fits Weber Genesis II Fits Weber Summit Weber Gas Grill Low Flame or No Gas Flow? Hose & Regulator Kit 67069 – Fix Pressure & Restore Full Flame Fast A failed or clogged gas regulator is one of the most common causes of a Weber gas grill that won’t light, produces a very low flame, or loses pressure mid-cook. In Weber Spirit II, Genesis II, and Summit series grills, the hose and regulator assembly connects the propane tank to the burner valves and controls gas pressure delivery. When the regulator fails, sticks in safety mode, or the hose cracks, the grill will produce a weak flame or no flame at all — even with a full tank. ⚡ Common failure point in Weber propane grills after extended use, storage, or a pressure surge event. Kit 67069 is the direct replacement 5FT hose and regulator assembly that restores proper gas pressure and full flame output to your Weber grill. ❓ Is This the Right Part? This is the correct fix if ALL of the following are true: ✔ The propane tank is confirmed full and the valve is open ✔ Burner tubes and venturi ports are clear of blockages ✔ The igniter sparks normally (ignition is not the issue) ✔ ONLY problem is very low flame, no gas flow, or regulator stuck in bypass/safety mode Not sure? Send us your model number — we’ll confirm before you order. 🔧 Common Symptoms Grill lights but flame is very low and won’t increase Grill won’t light at all despite a full propane tank Regulator hisses, leaks, or smells of gas near the connection Hose is cracked, kinked, or shows visible wear or damage Grill worked fine, then suddenly lost pressure mid-cook after a tank swap ✔ If these symptoms match, this is the most likely failed component in the system. ✔ In most cases, replacing this hose and regulator kit restores full gas pressure and flame output immediately. 📦 Part Details Part Number: 67069 Type: 5FT Propane Hose & Regulator Assembly — Weber-compatible replacement Replaces: 67069, 69891 Fits: Weber Spirit II (2017–2019), E210, E310, E320, Genesis II 210, LX240/300/400, Summit 400/600, Silver/Gold/Platinum Series Hose Length: 5 feet Connection: Standard propane QCC1/Type 1 fitting ⚠️ Recommended While Repairing: While the regulator is off, inspect the burner tubes and crossover tubes for rust, blockages, or insect nests — clogged burner ports cause the same low-flame symptoms as a bad regulator and are often found together. Also check the propane tank valve for damage or debris. Cleaning the burners at the same time as replacing the regulator ensures the new kit performs at full capacity. ⚙️ Installation Skill Level: Easy — 10–20 minutes. Ensure the propane tank is fully closed before beginning. Disconnect the old regulator from the tank and the burner manifold, remove the old hose, and connect the new 67069 hose and regulator in reverse order. Open the tank valve slowly, check all connections for leaks using soapy water, and test ignition before cooking. ✓ Compatible Models Confirmed compatible with Weber Spirit II (2017–2019), Spirit E210, E310, E320, Genesis II 210, Genesis II LX240/300/400, Summit 400/600, and Silver/Gold/Platinum series grills. Contact us to verify your model number before ordering. 💡 Pro Tip Reset the Regulator Before Replacing It: Weber regulators have a built-in safety bypass that activates when gas is released too quickly — like opening the tank valve with a burner knob already turned on. This puts the regulator into a low-flow safety mode that mimics a failed regulator. Before replacing, try a full reset: turn off all burner knobs, close the tank valve, disconnect the regulator from the tank, wait 60 seconds, reconnect, open the tank valve slowly, then light normally. If the flame is still low after a reset, the regulator is genuinely failed and this kit is the correct fix.