Performance Driveshaft - Chevrolet | Camaro SS | 2WD | 6.2L | 2010-15 | Carbon Fiber

Chevy Camaro Complete One Piece Conversion Driveshaft Convert your OEM 2 piece steel driveshaft to this high quality 1 piece carbon fiber shaft This driveshaft features a carbon fiber tube, aluminum end yokes, Spicer non-greaseable u-joints, and aluminum flanges. Every driveshaft is precision balanced and ready for install upon arrival. Compatible Applications: Chevrolet, Camaro SS, 2WD, 6.2L, 2010-2015 Heavy Duty 3.8 Inch Carbon Fiber Driveshaft The factory two-piece steel driveshaft relies on a center carrier bearing that wears over time, when it goes, you get vibration, shudder, and clunking. Our one-piece carbon fiber conversion eliminates the carrier bearing entirely. Fewer parts, fewer failure points, and a driveline built for performance. Carbon fiber is the ultimate driveshaft material for high-horsepower Camaros. It's lighter than aluminum, stronger than steel, and dampens driveline vibration better than both. Whether it's a high-performance street car or a dedicated track build, this shaft delivers faster acceleration, smoother power delivery, and the highest critical speed rating of any material available. The 3.8" OD carbon fiber tube is paired with Spicer cold-forged sealed u-joints, the best and strongest 1350 series u-joints on the market. Installation is a direct bolt-on. Remove the old two-piece shaft, bolt up the front and rear flanges, and you're done. You will need to check for clearance around the old carrier bearing mounting bracket, in most cases the bracket needs to be trimmed or removed so the new driveshaft clears properly. You won't be disappointed with your 3.8 inch carbon fiber driveshaft. Time and again customers are impressed at how well made the driveshaft is and better yet, how it helps solve vibration and carrier bearing problems - no matter how you use your Chevrolet Camaro, carbon fiber is the way to go. FREE GROUND SHIPPING INSIDE THE USA - This product does not qualify for international shipping - All custom driveshafts have a required build time Specs Vehicle Fitment Brand: Action Machine Inc Converts: Two Piece Steel Driveshaft to a One piece Carbon Fiber Material: Carbon Fiber Tubing / Aluminum End Yokes Tube Outside Diameter: 3.810 Inch Driveshaft Length: Flange Face to Flange Face Custom U-Joint Series: 1350 Hardware: QTY. 6 M10-1.5 Bolts Make: Chevrolet Model: Camaro SS Year: 2010-2015 Drive Type: Rear Wheel Drive / 2WD Trans: Automatic / Manual Engine: 6.2L Required Driveshaft Measurements: You can place your order today and we will send a follow up email requesting your driveshaft length or your can submit your measurement below. Measure from the face of the transmission output flange to the face of the differential flange. We cannot complete your driveshaft order until we have your driveshaft length. Note: The rubber flex discs will need to be removed before installing the new driveshaft. If you have any questions we are here to help: CHAT| PHONE(574)287-9650| CONTACT US FREE GROUND SHIPPING INSIDE THE USA (This product does not qualify for international shipping)