FrSky Pilot Gear Controller (PGC) Gear Controller Module for RC Turbine Jet/Plane Landing Gear, Brake, Gyro

OverviewThe FrSky Pilot Gear Controller (PGC) is a gear controller module for RC jets/planes with landing gear and doors. It integrates landing & door gear control, adjustable braking performance, and wheels’ gyro assist (steering and brake) to support smoother take-off and landing handling.The PGC also provides a stable, flexible power system with three independent BEC voltage outputs. It supports a one-battery solution to power the PGC and connected landing gear devices and receivers.Key Features Landing & door gear control system Adjustable braking performance Wheels’ gyro assist capability (steering and brake) 3 independent, separately adjustable BEC voltage outputs (V1/V2/V3) Stable and reliable voltage output supply Specifications Dimensions (L x W x H) 68.6 x 50 x 18 mm Weight 81.6 g Battery input connector XT30 Battery voltage input range 8.4-60 V Operating current 65 mA @ 12 V Adjustable voltage output range 6.0 V to 12 V BEC outputs V1, V2, V3 (separately adjustable 6.0-12 V) Note: 6-12 V output can be fully adjustable when powered by a 4S to 14S battery. When powered with a 2S/3S battery, the output voltage can be adjustable, but cannot reach 12 V (upper limit is less than input voltage).Interface & Controls Ports labeled for Brake1 and Brake2 Ports labeled for Gear1, Gear2, and Gear3 AUX port block labeled: Steer Out, Door1, Door2, Door3 Receiver signal ports labeled: FBUS/Port and SBUS (as marked on the unit) VBAT marking on the unit Button functions (as labeled): Roll up, Roll down, Return Button Operation (as labeled) Short click: Switch of Main menu options (GEAR/BRAKE/DIRE Settings). Long click: Save the settings after programming. Enter into the setting status. Notice: Some pins are marked as not defined functions and are unpowered.For setup and compatibility questions before purchase, contact support at https://rcdrone.top/ or email support@rcdrone.top.Details Compact 68.6 × 50 × 18 mm controller with labeled ports, Roll up/Roll down/Return programming buttons, and three independently adjustable BEC outputs (V1/V2/V3).