US MADE Polaris RZR 1000 Overhead Fans 2018-2023

Upgrade your rides with a RZR 2018-2023 Overhead Fans By Inner Demon Motor sports. Our US-made, one-piece plug and play system boasts dual 10" Spal Fans. Enjoy industry-leading power and efficiency with ease. What makes this an industry leading Overhead Fans? IP 68 Dual 10 inch 802 CFM Spal Fans MAX CFM 1604! IP 68 Dual control lighted switches for each of the Fans IP 68 lighted on/off switch for the lights One PCS 1/8" power coated aluminum frame Stainless hard ware Plug and Play wire connections to the pulse bar Only, Two crimp connections are required for main harness. Keyed powered with pulse bar connection. 4 year warranty 25 amp max amp draw Running draw of 13 amps The kit will include the following Qty 1 Cyclone Overhead fan assembly with power disconnect Qty 1 Mounting Kit Qty 4 1.75" Clamps Qty 4 M6x30mm bolts Qty 4 rubber gasket washers Qty 4 stainless washers Qty 4 M6 nylock hex nuts Wiring harness Qty 1 40 amp dual fused IP68 relay with Pulse bar plug 8 Foot power harness to run inside (recommended) of the cage or the outside of the driver side A Pillar. One side with a power disconnect and the other side bar to make the final connections. Tools required M10 driver/open end wrench /ratchet wrench with 10mm socket Phillips screw driver Wire terminal crimpers/strippers/cutters Designed, Built and tested in The USA. For Riders by Riders Installation Remove front section of the roof Route the 8 foot power wire through drive side A-Pilar and the dash into the front hood compartment area close to the pulse bar. The plug is for the fans and remains on the top side. Snap the Profit cage over brackets on to the machine from the out side in. They are tight and will flex/bend over a snap into place. when bolting down the over head to the bracket the sequence is Bolt gasket washer then through the Frame of the overhead through the bracket washer nylock nut Its best to have help holding the over into place as you get the first two bolts started DO NOT tighten the overhead down until all four bolts are in place and the over head is square between the cage. Then tighten down Connect power plug to over head harness at the fans. Plug the relay assembly into the open pulse bar slot OR connect the relay leads with the ring terminal White = ignition power Black= relay ground Red= Constant power Mount the relay Trim power leads from the Overhead to length and connect BLACK to BLACK to the open connector RED (from long harness) Blue lead from the Relay Test over head and reassemble roof. *Pictures are representation of the overhead assembly and may not represent the current version of the product.