Wallpaper Glue

Glue for non-woven (TNT) wallpapers that offers good coverage with excellent adhesion if applied properly. Easy to prepare (just add water and stir) and to install (the wall is glued). Properties: Made with methylcellulose and high-quality starch. Resistant to lime and cement. Dries without leaving stains. Surface preparation: The surface to be wallpapered must be dry, clean, firm, smooth, and slightly porous. Any cracks or holes must be sealed with putty. If the wall is very porous, it is recommended to apply a coat of glue first over the entire surface using the pre-pasted water ratio according to the preparation instructions (8 liters of water per package) and let dry for one day. Then, proceed normally with the installation. USE Liters of water per package Package sufficient for: Pre-pasted 8L 60 m2 Non-woven wallpaper 5L 35 m2 Fiberglass 4L 30 m2 Preparing the mixture: Pour cold water into a clean bucket according to the table and add the package contents, stirring continuously. Wait 5 minutes and stir the mixture well again. Your AS Creation glue for non-woven wallpapers is now ready for use. Yield: 5-7 rolls. Important points: - All ALF&mabi wallpapers are non-woven type, therefore, they are suitable for this type of glue. - The glue should go on the wall (and not on the wallpaper) Make sure to clean well the excess glue that remains on the wallpaper during installation before the glue dries.