DJI Power 1000 V2 Portable Power Station

DJI Power 1000 V2 for Australia One power station. Serious room to work. The DJI Power 1000 V2 portable power station combines a 1024 Wh battery with up to 2600 W continuous output under DJI test conditions. At approximately 14.2 kg, it is built to move between astronomy field sessions, home backup, vehicle-based trips and mobile work. 1024 Wh battery capacity 2600 W continuous output under DJI test conditions 56 min full recharge in Fast Recharge Mode under DJI laboratory conditions 26 dB measured at 100 cm in Standard Recharge Mode High-power USB-C. Two USB-C ports can each supply up to 140 W to a compatible PD 3.1 device when used with an EPR-rated cable. Two USB-A ports add up to 24 W each for lower-power equipment. DJI Home, built in. Integrated wireless connectivity links directly to Wi-Fi and DJI Home for status, settings and firmware management. No DJI Power Dongle is supported or required. Made for a physical setup. Alongside its power connections, two 1/4-inch threaded mounting points provide a documented attachment option for compatible accessories. LFP battery chemistry Built around repeat use, not a short ownership cycle. DJI states that the LFP battery retains more than 80% capacity after 4000 complete cycles. That result was measured at 25 C in Standard Mode with a 1000 W discharge load, so it is a durability reference rather than a promise for every pattern of use. Three recharge paths Recharge where the next job starts. 01 Use grid power. Connect the included AC power cable. Fast Recharge Mode can reach full charge in 56 minutes, or 80% in 37 minutes, under DJI laboratory conditions. 02 Build a solar setup. Compatible accessories enable solar input up to 1800 W, combined solar and car input up to 1200 W plus 600 W, or up to 400 W through the DJI Power Solar Panel Adapter Module. Accessories are sold separately. 03 Recharge from a vehicle. A compatible DJI high-power car charger can provide up to 1000 W vehicle recharging. The charger and installation hardware are sold separately. DJI drone battery fast charging Power that speaks DJI. With the corresponding SDC fast-charge cable, the station supports batteries from the DJI Matrice 4, Mavic 3, Air 3, Matrice 30 and Inspire 3 series. Drones, batteries and SDC cables shown are sold separately. Astronomy field sessions. Treat the 1024 Wh capacity as an energy budget for the whole setup. Add the real draw of your mount, cameras, dew control, focuser, mini PC or laptop and networking equipment. Check startup demand as well as continuous load; usable runtime varies with the equipment, output method and temperature. Backup for appropriate devices. In UPS mode, DJI measured the station beginning to power connected devices within 0.01 seconds in a controlled laboratory test. Confirm that the connected equipment is suitable for this transfer behaviour. Camping and quieter mobile work. Grid, solar and vehicle recharge options help adapt the setup to the trip. DJI measured 26 dB at 100 cm during Standard Recharge Mode, a useful reference where charging noise matters. Actual sound varies with mode, load and environment. Choose the right DJI connection. SDC High-power accessories and expansion. Use the SDC port for compatible fast car and solar chargers, supported DJI drone cables, and up to five separately sold DJI Power Expansion Battery 2000 units for as much as 11264 Wh total capacity. SDC Lite Lower-power applications. SDC Lite has different electrical limits and does not support expansion batteries or DJI's 1 kW and 1.8 kW fast car and solar chargers. Sold separately Match the cable to the job. Solar, vehicle, expansion and drone fast-charge functions require the corresponding compatible accessory. None of those accessories is part of the base package. In the box. DJI Power 1000 V21x DJI Power AC power cable1x Good to know. The Australian version has two AC outlets. Four-outlet specifications and imagery apply only to the Chinese, United States and Japanese versions. The Australian high-voltage DYM1000V2H model has two AC output outlets. 140 W USB-C needs the right device and cable. Maximum USB-C output requires a PD 3.1-compatible device and an EPR-rated cable. Other combinations will negotiate a lower supported power level. Cold conditions reduce output capability. DJI publishes a power-supply range down to -10 C, but notes that output capability is reduced at low temperatures. Store the battery with charge in reserve. For long-term storage, DJI recommends 50% to 70% charge, a check every three to four months, and a maintenance cycle about every six months. SDC and SDC Lite are not interchangeable. SDC Lite cannot be used for expansion batteries or DJI's 1 kW and 1.8 kW fast car and solar chargers. Check the accessory connection before building a recharge or expansion system. Common questions. How long will it run an astronomy setup? There is no honest one-size runtime. Start with the 1024 Wh capacity, total the measured watt draw of every connected astronomy device, and allow for the output method, temperature and changing loads through the night. Low temperatures reduce the station's output capability. Can it act as a UPS? Yes. In DJI's controlled laboratory test, UPS mode began powering connected devices within 0.01 seconds after a grid interruption. Confirm that your equipment is appropriate for this transfer characteristic. Can I add more battery capacity later? Yes. The SDC port supports up to five separately sold DJI Power Expansion Battery 2000 units, taking the documented total capacity to as much as 11264 Wh. Does app control need a dongle? No. The Power 1000 V2 has built-in wireless connectivity for Wi-Fi and DJI Home. It does not support or require the DJI Power Dongle. Why did the station turn itself off? If there is no continuous output, the default automatic shut-down time is 30 minutes. The timing can be changed in DJI Home. Specifications. General Model DYM1000V2H (Australia / high-voltage version) Net weight Approx. 14.2 kg Dimensions 448 x 225 x 230 mm Maximum operating altitude 5000 m Battery Cell chemistry LFP (lithium ferrophosphate) Capacity 1024 Wh Cycle life Over 80% capacity after 4000 cycles under DJI test conditions AC output Continuous output 2600 W under DJI's stated 25 C test condition Voltage and current 220-240 V, 50/60 Hz, max. 10.9 A Bypass output 220-240 V, max. 10 A AC outlets 2 (Australian version) USB and physical connections USB-C 2 ports, up to 140 W each; PD 3.1 device and EPR cable required for maximum output USB-A 2 ports, up to 24 W each SDC / SDC Lite 1 SDC and 1 SDC Lite Threaded mounts 2 x 1/4-inch DC output SDC output 9-28 V or 32-58.4 V, max. 42 A SDC Lite output 9-27 V, max. 10 A Input and recharging AC input 220-240 V, 50/60 Hz, max. 6.5 A AC bypass input 220-240 V, 50/60 Hz, max. 10 A SDC input 32-58.4 V DC, max. 60 A SDC Lite input 32-58.4 V DC, max. 8 A Fast Recharge Mode 0-100% in 56 min; 0-80% in 37 min under DJI laboratory conditions Recharge methods Grid; solar with compatible accessory; vehicle with compatible accessory Accessory-dependent input options Up to 1000 W car; up to 1800 W solar; up to 1200 W solar plus 600 W car; or up to 400 W through the MPPT module Expansion, backup and DJI ecosystem Expansion batteries Up to 5 DJI Power Expansion Battery 2000 units; up to 11264 Wh total UPS response Begins powering connected devices within 0.01 s in DJI laboratory test Supported DJI battery families Matrice 4, Mavic 3, Air 3, Matrice 30 and Inspire 3 series with corresponding SDC cable SDC Lite limitation No expansion battery or DJI 1 kW / 1.8 kW fast car and solar charger support Acoustics and environment Charging noise 26 dB measured at 100 cm in Standard Recharge Mode Power supply temperature -10 to 45 C; output capability is reduced at low temperatures Recharging temperature 0 to 45 C Storage temperature -10 to 45 C Long-term storage care Maintain 50% to 70% charge; check every 3-4 months; complete a maintenance cycle about every 6 months Wireless and controls Wi-Fi 802.11 b/g/n, 2.4000-2.4835 GHz, under 20 dBm; regional availability applies Bluetooth Bluetooth 5.0, 2.4000-2.4835 GHz, under 7 dBm App Direct Wi-Fi connection to DJI Home; DJI Power Dongle not supported or required Default automatic shut-down 30 minutes without continuous output; adjustable in DJI Home Included items DJI Power 1000 V2 1 DJI Power AC power cable 1