Adapter RSAMG80 with Thread and Reflective Targets (pack of 25)

Shipping: Estimated 5-8 Days Adapter RSAMG80 with Thread and Reflective Targets (pack of 25) The RSAMG80 Metal Adapter turns Smart Angle Targets into all-angle control monuments. Uses: • Bridge construction and bridge monitoring • Tunnel construction • Monitoring earth and rock movements • Enables measurements and monitoring to be carried out from almost any angle, in cramped conditions and at locations which are difficult to access • The clip system allows the original measurement point to be restored quickly and cheaply in the event of damage • Many measurements can be carried out within a short time when used with current total stations • Drilling is not required, as pre-installed anchor sleeves for DW15 threads can be used for mounting • Anchor sleeves can be used during the construction phase for measurement points – above and below the bridge bearing, in the case of supporting structures and in many other applications Ranges: • Target reflectors w/ cross hair 30 x 30 mm: range approx. 80 m (262 ft) • Target reflectors w/ cross hair 40 x 40 mm: range approx. 100 m (328 ft) • Target reflectors w/ cross hair 60 x 60 mm: range approx. 120 m (393 ft) The ranges are average values and will be greatly exceeded by the majority of current total stations, some of them need a minimum distance of 10 meters. Attention: – It is recommended that only reflective targets are used for distance measurements using a total station – Targets with cross-hairs (non-reflective) are especially for use with auto levels, theodolites and construction lasers Return: 14 days money back or replacement buyer pays return shipping 20% restocking fee may apply