Atlas® 9,000 lb Baseplate 2-Post Lift #ATEXH-TPF-9-FPD

Quick Specs - Atlas TPF-9 9,000 lb 2-Post Lift Capacity 9,000 lbs Overall Height 111 1/2" (no overhead beam) Lifting Height 76 1/2" (79 1/2" w/ adapters) Floor Width 133 1/2" Power 220V 1-Phase, 30A Concrete 4" min, 3,000 psi Warranty 2 yr structural / 1 yr hydraulic 🔧 Will the Atlas TPF-9 Fit Your Bay? Three measurements decide it — take them before you order, not after it arrives. CEILING 111 1/2" total column height — no overhead beam; add vehicle height at full rise FLOOR WIDTH 133 1/2" installed footprint — confirm wall & door clearance MAX VEHICLE WEIGHT 9,000 lbs verify loaded vehicle weight before ordering 📞 Close on any of the three? Call Alamo at (817) 865-3707 and we will walk through your measurements before you order. 🏗 Site Prep - What Your Bay Needs Before Install Day Have these three things ready and installation day is boring — in the good way. 🧱 Concrete Minimum 4" of concrete, 3,000 psi rating Baseplate design — check floor flatness in the anchor zones Confirm before the truck arrives ⚡ Power 220 volt single-phase, 30 amp breaker Dedicated circuit recommended Have an electrician confirm final service 📐 Bay No overhead beam — clears low bays Verify door tracks, lights, and ducts Confirm vehicle raised height before ordering 🔨 Alamo installs and services the lifts we sell. Call Alamo at (817) 865-3707 to review your bay, electrical setup and installation requirements. Product DetailsProduct FeaturesProduct SpecsWarranty Information Atlas TPF-9 — 9,000 lb Baseplate (Open-Top) 2-Post Lift An overhead two-post doesn't care that your shop has a 10-foot ceiling — the beam is the problem, and the ceiling isn't moving. The Atlas TPF-9 is the baseplate, open-top answer: a 9,000 lb symmetric two-post with no crossbeam overhead, standing 111 1/2 inches so a low bay still gets a full 76 1/2-inch working rise (79 1/2 with adapters). The floor plate carries the equalization instead of a top beam, so everything the ceiling would have blocked is at floor level — and the lift keeps the safety kit that matters: a spring-loaded Secondary Lock System, automatic arm restraints, and dual-point lock release. Who the Atlas TPF-9 Is Built For Shops with low ceilings — 111 1/2" of column height fits the 9–10 ft bays that overhead-beam two-posts can't enter, no building modifications required. General-service bays on sedans, SUVs, and 3/4-ton pickups — 9,000 lbs with symmetric arms and a 98 1/2" drive-thru for the daily vehicle mix. Techs who spot symmetric and want it to stay that way — symmetric columns and arms on every lift point, with automatic arm restraints that engage on rise. Shops that value the safety kit — the spring-loaded Secondary Lock System (SLS) plus dual-point lock release is real redundancy, not a marketing line. Bays already verified for the install — 4" of 3,000 psi concrete and 220V single-phase on a 30 amp breaker — so the TPF-9 drops into a bay that's ready. What the Atlas TPF-9 Is NOT Built For This is not the lift for shops needing maximum under-lift clearance — the baseplate means floor-level hardware where an overhead design keeps the floor clear (see the TPO-9 for that trade). It's also not for anything over 9,000 lbs, not for ceilings so low that 111 1/2" plus a raised vehicle won't clear, and not for alignment work. Important sizing note: measure ceiling against the 111 1/2" columns plus vehicle height at full rise, floor width (133 1/2"), and confirm loaded weight before purchase. What Makes the Atlas TPF-9 Different Open top — the low-ceiling two-post No overhead beam: the columns stand 111 1/2" tall and the floor plate handles equalization, which is the whole reason this lift exists. 111 1/2" overall height Baseplate / open-top design 76 1/2" rise (79 1/2" with adapters) Safety kit that earns its keep Spring-loaded Secondary Lock System, automatic arm restraints, and dual-point lock release — the features that keep a 9,000 lb load predictable. Comes ready to work Adjustable screw-up adapters, a free 4-piece truck adapter set, free sliding arm adapters, and mounting hardware included — freight prepaid. Best For Low-ceiling bays (9–10 ft) General service to 9,000 lbs Symmetric spotting Baseplate installations Not Ideal For Shops needing clear-floor space (see TPO-9) Vehicles over 9,000 lbs Very low ceilings Alignment work Atlas TPF-9 vs Atlas TPO-9 — same 9,000 lb platform, two ceiling answers Spec Atlas TPF-9 (Baseplate) Atlas TPO-9 (Overhead) Overhead beam None — open top Yes — clear floor Overall height 111 1/2" 144" (12') Floor hardware Baseplate at floor level Floor stays clear Lifting height 76 1/2" (79 1/2" w/ adapters) 76 1/2" (79 1/2" w/ adapters) Drive-thru 98 1/2" 99 1/2" Shipping weight 1,400 lbs 1,450 lbs Same capacity, same safety kit — the choice is your ceiling: low bays take the TPF-9, tall bays get the clear floor of the TPO-9. Full Specifications - Atlas TPF-9 Capacity 9,000 lbs Design Baseplate, open-top 2-post lift; symmetric columns and symmetric arms Overall height 111 1/2" (9' 3 1/2") Overall floor width 133 1/2" (11' 1 1/2") Max lift height (without adapters) 76 1/2" Max lift height (with adapters) 79 1/2" Minimum arm height 4" Inside column 111 3/8" (9' 2 3/8") Drive-thru 98 1/2" (8' 2 1/2") Column size 7 1/4" x 11" Column steel thickness 5mm Base of lift 14 1/4" x 18" Motor / electrical 220 volt single (1) phase; 30 amp breaker recommended Oil requirement 3–5 gallons AW32/AW46 (NOT included) Shipping weight 1,400 lbs Adapter heights 4 each 2.75" Arm hole adapter peg size 2" Concrete requirement Minimum 4" of concrete with 3,000 psi rating Features Dual hydraulic chain-drive cylinders; spring-loaded Secondary Lock System (SLS); automatic arm restraints; dual-point lock release; adjustable screw-up adapters included; free 4-piece truck adapter set; free sliding arm adapters; mounting hardware included; freight prepaid ⚠️ Installation Requirements Anchor per the manufacturer's installation requirements — minimum 4" of 3,000 psi concrete Electrical: 220 volt single-phase on a 30 amp breaker — have an electrician confirm service Hydraulic oil: 3–5 gallons AW32 or AW46 (not included) Mounting hardware included Alamo installs every lift we sell — one team for anchoring, wiring, and setup Setup or fit questions? Call Alamo at (817) 865-3707 — we sell, install, and service this equipment. Atlas® Automotive Equipment Warranty - Atlas TPF-9 Atlas covers the TPF-9 with the standard two-post warranty — structure and hydraulics, parts only, handled through Alamo. Component Coverage Term Steel structure 2 years Hydraulic components 1 year (parts only) Warranty service is coordinated through Alamo Equipment & Service — call (817) 865-3707 and we help get the issue moving. Warranty terms can change. Confirm exact coverage at the time of purchase. Warranty can be void if the lift is installed improperly or not anchored per spec. ❓ Frequently Asked Questions - Atlas TPF-9 What's the difference between baseplate and overhead two-post lifts? A baseplate (open-top) lift like the TPF-9 has no overhead beam — the floor plate handles cable equalization, so the lift fits low ceilings. An overhead lift like the TPO-9 spans the bay with a top beam and keeps the floor clear. Will the TPF-9 fit my 10-foot ceiling? Very likely — the columns stand 111 1/2" (9' 3 1/2") with no beam overhead. Confirm vehicle height at full rise (76 1/2" to runway... plus the vehicle on the arms) against your actual clear ceiling. What power and concrete does it need? 220 volt single-phase on a 30 amp breaker, and minimum 4 inches of 3,000 psi concrete. Hydraulic oil (3–5 gallons AW32/AW46) is not included. Do adapters come with it? Yes — adjustable screw-up adapters, a free 4-piece truck adapter set, and free sliding arm adapters are included. Why Buy the Atlas TPF-9 from Alamo Equipment & Service? We install it. Baseplate installs are floor-critical — our crew checks flatness and anchoring before the columns go up. We service it. SLS checks, chain-drive service, and hydraulics from the team that installed it. We size the bay with you. Send the ceiling number before you order — we'll confirm the TPF-9 is the right ceiling answer, or tell you honestly when it isn't. Freight handled. Freight prepaid on this lift; we coordinate delivery to your shop. Expert comparison help. Baseplate vs overhead is a real trade — call and get the straight version for YOUR bay, not the catalog's. A shop buying from a pure e-commerce retailer gets a box. A shop buying from Alamo gets a partner. Call (817) 865-3707 or email our team. Related Products & Collections Atlas TPO-9 9,000 lb Overhead 2-Post Lift - the clear-floor overhead version of this platform Atlas Platinum PVL15 15,000 lb 2-Post Lift - the 15K ALI-certified Platinum two-post Atlas 412 12,000 lb 4-Post Service Lift - four-post service alternative Talk to Alamo - we install and service every lift we sell