Special Adept Buy - 5.1 System - 3 x AA-ICLCR6, 2 x AA-IC62 and 1 x AA-ADS10

Adept Audio ICLCR62 (FRONT Left, Centre, Right) 6.5″ Click in - Pivoting Silk-Dome Inceiling . The ICLCR62 makes high-quality home theater practical in any room, and within any budget. It packs all the stealthiness of our higher-end ceiling LCRs, in an affordable design perfectly tweaked by our expert engineers. We’ve all heard the objections to home theater—it’s too complicated, too costly, and it makes a living room look like a recording studio. The ICLCR62 puts every one of those objections to rest. It’s our most affordable ceiling LCR—and the most affordable way to get your Netflix shows sounding like they would in a commercial cinema. Mount three ICLCR62s in the ceiling above your TV screen, and add two or four more for the surround channels. Or use any of our other ceiling speakers for surrounds, because our team of the world’s most experienced architectural speaker engineers voiced them all to mix and match. The ICLCR62’s pivoting sweet-sounding silk dome tweeter assures that every whisper of dialogue is as clear as it was on the sound stage. Through our engineering team’s carefully designed crossover, the tweeter blends perfectly with our tough 6 ½” IMP polypropylene cone woofer. Because the speaker’s angled, you can point it where listeners will sit, and get sound that’s surprisingly similar to what you’d hear from a freestanding home theater speaker system. And the pivoting tweeter lets you direct the highs exactly where you want them. Like all of our other ceiling speakers, the ICLCR62 uses our In the Ring toolless mounting system. All you need to mount the ICLCR62 is your bare hands! Just lift the ring into the hole, point it where you want the sound to go, and squeeze down on the four mounting clamps. Twist the speaker into the ring, pop on our magnetically attached grille, and you’re ready to go. And did you notice we said nothing about a screwdriver? That’s because you won’t need one! Woofer 6 ½” Polypropylene Tweeter 1” Pivoting Silk-Dome Frequency Response 50Hz-20kHz Power Handling 100 Watts Warranty Limited Lifetime Adept Audio IC62 (REAR SPEAKERS) 6.5″ Click in - Pivoting Silk-Dome Inceiling speaker With the IC62, our team of the world’s most experienced architectural speaker engineers wanted to prove it’s possible to build a ceiling speaker affordable enough for any job, but that still delivers satisfying sound. And they did it! You’ll want to keep the IC62 in stock because you’ll find places in every single job where you can use it. The IC62 is affordable enough to use in the laundry room but good enough to use in the living room. Our engineers tapped their decades of experience to produce an amazingly affordable speaker that genuinely sounds great. You’ll love it whether it’s playing background music in a hallway or cranking out classic jams from your favorite streaming service in the living room. The IC62 packs surprising power even in the deep bass notes, thanks to our rugged 6 ½” polypropylene-cone woofer. Its low-distortion, stiff, lightweight cone delivers crystal-clear midrange—and lets it blend seamlessly with our pivoting 1" silk-dome tweeter. Thanks to careful tuning from our team of veteran engineers, the IC62 sounds sweet and strong from bottom to top. And with careful voicing and design from our engineering team, the IC62 is tuned to sound good everywhere in a room, not just near the speakers. Our Tool-Less Trim-Ring mounting system really pays off with the IC62, because you’ll probably be putting in a lot of these! It’s totally tool-less—just insert the ring into the hole and squeeze down on each of the four mounts with your fingers. You don’t even need a screwdriver! And that means you can put in a whole houseful of IC62s in no time. Woofer 6 ½” Polypropylene Tweeter 1” Pivoting Silk-Dome Frequency Response 55Hz-20kHz Power Handling 85 Watts Warranty Limited Lifetime Adept Audio ADS10 (SUBWOOFER) 10″ Digital Dual Drive Subwoofer With a compact design, rugged 10” drivers and a powerful 200-watt amp, the ADS10 is the sub you need when your home theater dreams are limitless—but your space isn’t. Anybody can appreciate great bass. Everybody wants great bass. But big bass usually means big speakers, and not everybody wants those—or has the space for them. That’s why we built the ADS10. It’s small enough to stay out of sight—but big enough to deliver soul-stirring deep bass! The ADS10 starts with a rugged, forward-firing 10” driver that delivers incredible punch. It finishes with a downward-firing 10” passive radiator that delivers intense rumble. Put them together, drive them with our 200-watt digital amp, and you get amazing bass from the deepest whomps of action-movie explosions to the tightest pops of funk basslines. We give you all the crossover and level controls you need to mate the ADS10 with any home theater or stereo system. In seconds, the bottom end is dialed-in perfectly, and the thrilling nights of movie and music can get started! Frequency Response 28Hz – 200Hz Power Handling 200 Watts RMS Woofer 10" Treated Paper Passive Radiator 10" Treated Paper Warranty Limited 3 years