HX Cooler Kit - 1 GPU - 120 mm PWM Fan Manifold for CMP 170HX / A100

1 GPU · 120 mm PWM · EPS converter included HX Cooler Kit — 1 GPU A sealed fan manifold that turns a passive datacenter accelerator into a card you can actually run at home. Ducts a 120 mm PWM fan straight through the heatsink of a CMP 170HX, an A100 or any card of the same body, and ships with the PCIe-to-EPS converter needed to power it from an ordinary desktop supply. 1 GPU Cards cooled 1× 120 mm PWM fan 6,000 RPM Peak fan speed 1 × EPS Power converters The problem A datacenter GPU has no fan of its own Every passive accelerator — the CMP 170HX, the A100, the whole Tesla line before them — ships as a bare finned heatsink with no fan attached. In a rack that is deliberate: a 2U chassis puts a wall of 15,000 RPM fans in front of the cards and forces air down their length. Drop the same card into a desktop tower and there is no such wall. Case airflow drifts past the heatsink instead of through it, the card heat-soaks within minutes, and you watch it clock down to nothing — or trip thermal shutdown. This kit supplies the missing half of the design. A 120 mm fan is sealed into a manifold that mates to the intake face of the heatsink, so every litre the fan moves is forced through the fins and out the back of the card rather than around it. It is the same principle as the server shroud, sized for one card on a desktop board. Without ducting, a 250 W passive card in a tower is not a slow card — it is a card that works for four minutes and then stops being useful. Ducted, it holds full clocks indefinitely. In the box What you get The manifold — a sealed plenum sized for one card, mating to the heatsink intake face. 1 × 120 mm PWM fan — 1,000–6,000 RPM, 2.7 A, 4-pin PWM control. 1 × PCIe-to-EPS converter — one per card, so nothing else is needed to power the GPU. Mounting hardware for the fan-to-manifold and manifold-to-card interfaces. Power Why the card needs a converter, not just a cable Datacenter cards take power through an 8-pin EPS inlet at the end of the card — the CPU-style connector, not the graphics-card one. It is the single most common way people destroy one of these on the first boot: an EPS 8-pin and a PCIe 8-pin look alike, and in the wrong hands one will go into the other. They are not the same. A PCIe 8-pin carries three 12 V lines and five grounds; an EPS 8-pin carries four and four, in a different arrangement. Cross them and you feed 12 V into a ground pin. The converter in this kit remaps the pins correctly and takes its feed from your PSU's PCIe cables, which every desktop supply has spare. Never adapt an EPS inlet with a plain re-pinned cable or a straight-through "8-pin to 8-pin" lead. Use a converter that is explicitly built for the direction you need. That is what ships here. Noise and control 6,000 RPM is the ceiling, not the setting The fan in this kit is an industrial-grade unit with a very wide range: it will idle near 1,000 RPM and it will pull 2.7 A flat out at 6,000. At the top of that range it is genuinely loud — this is server-class air movement and we are not going to pretend otherwise. The point of the 4-pin PWM control is that you almost never run it there. Put the fan on a curve tied to GPU temperature and a single ducted card sits comfortably in the 1,500–2,500 RPM band during sustained inference, which is quiet enough for a room you work in. The headroom above that is there for the days you saturate every card at once, or for a warm summer with no air conditioning. Check your fan header first. At full speed this fan draws up to 2.7 A — well beyond the ~1 A a typical motherboard chassis header is rated for. Feed the fan from the PSU (a hub with its own SATA or Molex input is the usual answer) and take only the PWM signal wire from the header. Ask us if you want the wiring spelled out for your board. Fitment Which cards this fits The manifold is cut for the standard NVIDIA full-height, full-length, dual-slot passive body — the 267 mm card with a finned tunnel running its whole length and the 8-pin EPS inlet at the far end. That covers CMP 170HX, A100 PCIe, A30, A40, L40, V100, P100 and P40, and the AMD Instinct cards of the same generation share the geometry closely enough to work. If your card is not on that list, send us the model before you order. The fit depends on two things only — the card body and where the power inlet sits — and we can tell you in a sentence whether it lands. Specifications Technical data Cards supported 1 × full-height, full-length dual-slot passive accelerator Fan 1 × 120 mm, 1,000–6,000 RPM Fan current Up to 2.7 A at 12 V, per fan Fan control 4-pin PWM Power converters included 1 × PCIe to 8-pin EPS Card power inlet 8-pin EPS at the end of the card Verified cards CMP 170HX, A100 PCIe, A30, A40, L40, V100, P100 and P40 Price €50 ex VAT Questions FAQ Do I need this, or will good case airflow do?You need it. Case airflow moves air through the case; a passive accelerator needs air forced through a narrow finned tunnel against real static pressure. Those are different jobs. Builders who skip the duct report the card idling fine and then collapsing under the first sustained load — which is exactly the load you bought it for. Is it loud?At 6,000 RPM, yes. On a temperature-driven PWM curve during normal inference work, no — it settles in the 1,500–2,500 RPM band. You control where on that range you live. Can I run the fan from a motherboard header?Take the PWM signal from the header, but not the power. At 2.7 A the fan exceeds what a standard chassis header is rated to deliver. Feed it from the PSU through a powered hub. Does the converter work with any PSU?Any ATX supply with spare PCIe 8-pin outputs, which is effectively all of them above 750 W. Size the supply for the cards: budget around 250 W per accelerator on top of the rest of the system. Will it fit my case?The manifold adds depth beyond the end of the card, so measure from the back of your PCIe slot to the front of the case or the drive cage. Tell us your case and card count and we will confirm before you order. Buying the cards too? We sell the CMP 170HX 64 GB and we build complete machines around these accelerators — see the AI Servers collection. Order the cooler alongside a card and it ships together.