NanoCeram® 0.2 Micron Pleated Filter 4.5 x 10 Inch

Electropositive 0.2 micron particulate filtration High-efficiency filtration with strong flow and low pressure drop The NanoCeram® P4.5-10 is a pleated 4.5 × 10 inch cartridge designed to capture extremely fine particles using electropositive attraction as well as depth filtration. Its high-surface-area media combines microglass, cellulose and nanoalumina fibres for residential point-of-entry filtration and specialist pre-filtration applications. Advanced charged-fibre media Captures fine particles without relying only on pore size The thermally bonded media forms an electropositively charged filtration matrix. Many suspended particles carry a negative charge, allowing the NanoCeram media to attract and retain them throughout the depth of the pleated cartridge. 99.9% reduction of 0.2 µm test particles More than 5 LRV retention for cysts and tested bacteria High dirt-holding capacity and large pleated surface area Suggested flow rate of 38 litres per minute Designed for compatible 4.5 × 10 inch housings 0.2µ Fine particulate reduction 99.9% reduction using 0.2 µm latex test particles. 38 Suggested flow 38 litres per minute for the P4.5-10 cartridge. 40K Published capacity Osmio lists an approximate 40,000-litre capacity. 12M Typical lifespan Osmio lists an average life of approximately 12 months. Electroadsorptive filtration How NanoCeram technology works 01Water enters the pleats The pleated construction exposes a large filtration surface while supporting a strong flow rate. 02Particles meet charged fibres Electropositive nanoalumina-infused media attracts oppositely charged suspended material. 03Depth capture retains particles Particles are adsorbed throughout the non-woven media rather than only being trapped at the outer surface. 04Filtered water continues downstream The cartridge provides fine filtration with lower resistance than many ultrafine membrane formats. Published performance Fine-particle, cyst, bacteria and turbidity reduction The attached manufacturer datasheet reports the following performance under its stated laboratory conditions. These results should not be treated as a substitute for water testing or an appropriately specified disinfection stage. 99.9%0.2 µm particles Reduction measured using monodispersed latex spheres. >5 LRVCyst retention Published log-reduction performance for cyst-sized contaminants. >5 LRVTested bacteria Published retention for Klebsiella terrigena. <0.01 NTUTurbidity Published turbidity output until the stated terminal pressure differential. ≤0.5Silt Density Index Low published SDI supports downstream membrane protection. 683.5 gDirt-holding capacity Based on A2 Fine Test Dust for the P4.5-10 cartridge. Flow and service life Designed for residential point-of-entry filtration The manufacturer datasheet lists a suggested flow of 38 L/min for the P4.5-10. Its 95 L/min peak figure was measured with a new cartridge and clean water during laboratory testing, so it should not be used as the normal design flow. 38 L/minSuggested flow rate The appropriate working figure for system planning. 95 L/minLaboratory peak flow Initial peak flow using a new cartridge and clean water. 40,000 LOsmio listed capacity An approximate guide that varies with water conditions and usage. 12 monthsAverage listed lifespan Replace earlier if pressure loss or water conditions indicate exhaustion. ✓ Compatible replacement cartridge Used as the final stage in the Osmio PROMAX-III Ultimate The NanoCeram P4.5-10 provides the fine particulate and microorganism-reduction stage within the compact PROMAX-III system. Confirm the cartridge size and system model before ordering for any other housing. View PROMAX-III → Technical information NanoCeram P4.5-10 filter specification Product NanoCeram® P Series Pleated Filter Cartridge Part number P4.5-10 Nominal format 4.5 × 10 inch Actual dimensions Approximately 4.45 × 9.75 inches / 11.3 × 24.8 cm Filter media Microglass and cellulose blend infused with nanoalumina fibres Filtration principle Electropositive adsorption combined with depth filtration 0.2 µm efficiency 99.9% reduction using monodispersed latex test particles Filter surface area 8.3 ft² / 0.771 m² Dirt-holding capacity Approximately 683,540 mg / 683.5 g using A2 Fine Test Dust Suggested flow rate 10 GPM / 38 LPM Peak laboratory flow 25 GPM / 95 LPM with a new cartridge and clean water Temperature range 4°C to 57°C Maximum pressure 70 psi / 4.83 bar Effective pH range 5 to 10 Osmio listed capacity Approximately 40,000 litres Osmio listed lifespan Average approximately 12 months Dry weight Approximately 0.5 kg Manufacturer technical data Review the NanoCeram product data The Osmio product page includes the manufacturer datasheet covering filter media, reduction efficiency, flow, dimensions, dirt capacity and operating limits. View manufacturer information Understand its role A particulate filter, not a chemical-treatment cartridge Designed forFine suspended material Particles, turbidity, cysts and tested bacteria captured through depth and electropositive filtration. Not designed forDissolved chemicals It does not replace activated carbon or specialist media for chlorine, chloramine, PFAS or fluoride reduction. Not a softenerHardness and limescale It does not remove dissolved calcium and magnesium or soften hard water. More from Osmio Browse Osmio filtration products Explore complete whole-house systems, reverse-osmosis products, replacement cartridges and water purifiers. Shop Osmio Helpful answers Frequently asked questions Is NanoCeram a conventional 0.2 micron membrane?No. It is a pleated depth-filter cartridge that combines fine filtration with electropositive adsorption. The datasheet reports 99.9% reduction of 0.2 µm monodispersed latex test particles, but it should not be described as a conventional absolute membrane. What is the recommended flow rate?The P4.5-10 datasheet lists a suggested flow of 38 litres per minute. The 95 L/min peak figure is based on initial laboratory flow with a new cartridge and clean water and is not the normal design flow. How often should the cartridge be replaced?Osmio lists an average lifespan of approximately 12 months and an approximate 40,000-litre capacity. Actual life depends on incoming turbidity, particulate loading, usage and pressure loss, so replacement may be required sooner. Does it reduce bacteria and cysts?The manufacturer datasheet reports more than 5 LRV retention for cysts and for the test bacterium Klebsiella terrigena. It should not be relied on as the sole treatment for microbiologically unsafe or unknown-quality water without an appropriately designed disinfection system. Does NanoCeram remove chlorine or fluoride?No specific chlorine or fluoride capacity is stated for this cartridge. It is primarily a fine particulate and microorganism-reduction stage. Use carbon or specialist media for dissolved chemical contaminants. Will it fit every 4.5 × 10 inch housing?Do not assume compatibility from the nominal size alone. The cartridge measures approximately 4.45 inches in diameter by 9.75 inches long. Check the housing specification and service clearance before ordering. Friendly expert support Need help confirming the correct NanoCeram cartridge? Send us the system model, housing size and a photograph of the existing filter. We will help check compatibility before you order. Telephone Email WhatsApp Contact form