GripEdge | RPT Hex Drive Bundle | Buy MH38S & Get BHBM6LS Free
Buy 1, Get 1 Free: RPT™ Hex Drive Bundle Hex fasteners fail two ways. A tight socket cap screw rounds out its broach when a standard bit contacts only the corners and wedges material outward under load, and a recessed fastener buried at the bottom of a counterbore never gets clean engagement at all. This bundle covers both problems. Buy the MH38S Master RPT™ Hex Bit Socket Set, a 38-piece set spanning the full metric and SAE range, and the BHBM6LS 6-Pc 3/8" Drive Long Metric Ball Hex Driver Set ships free. One set is your complete broad-coverage foundation; the other is the long-reach, angled-access specialist that gets into the spots a straight bit cannot. Both sets run on the same patented RPT™ geometry, so engagement behavior is consistent from the smallest 1.5mm bit to the largest 3/4" driver. Nothing here is a compromise piece. What's in the bundle MH38S: Master RPT™ Hex Bit Socket Set (38-Pc): Metric 1.5-19mm plus SAE 1/16" through 3/4". The complete socket-drive foundation for both new-fastener prevention and damaged-fastener extraction across nearly any hex you will encounter. BHBM6LS: 6-Pc 3/8" Drive Long Metric Ball Hex Driver Set (FREE): Sizes 4mm, 5mm, 6mm, 7mm, 8mm, and 10mm. Six-inch overall length with a second-generation ball end for angled access to recessed and obstructed fasteners. The engineering behind the grip RPT™ tooth geometry that pulls inward. Standard hex tools concentrate stress on the fastener corners and push material outward, which is what rounds a broach. RPT™ reshapes the tooth profile to shift the pressure point and pull material inward, forming a secure mechanical lock. Torque transfers into the fastener instead of around it, delivering up to 50% more grip on new fasteners and up to 400% more on damaged ones. Prevention and extraction in one tool. Because RPT™ grips new and compromised fasteners alike, these are not special-occasion tools. Reach for them first, every time, to prevent rounding before it starts, and rely on the same bits to remove a fastener that has already been chewed up, no separate extractor set required. Bi-directional engagement. The profile grips in both directions for loosening and tightening. When a replacement is not on hand, RPT™ can grip a damaged fastener well enough to drive it back in temporarily. Extended ball-hex access. The BHBM6LS pivots up to 22.5 degrees, a 50% increase over the first generation, and its reduced-thickness S2 bar reaches recessed hex screws that a standard driver cannot approach at an angle. Material and finish. Both sets are precision machined from S2 steel for strength and durability under load, with corrosion-resistant coating. The MH38S carries oversized, roll-stamped, ink-filled markings and nickel chrome plating; the BHBM6LS uses stamped, ink-filled markings and ships in a cut EVA foam tray. Two sets, one free, and one gripping principle from the smallest broach to the deepest counterbore. Don't strip it. GRIP IT. For a full breakdown of the tooth geometry and the torque figures behind it, see our RPT™ Technology page.