Underride Guard Complete Set for Ineos Grenadier Station Wagon

This 5053 aluminum-magnesium alloy underride guard complete set provides mechanical structural shielding for the chassis components of the 2023-2026 Ineos Grenadier Station Wagon. The protective plating bolts directly into the factory pre-drilled chassis holes and original mounting positions. This bolt-on implementation requires zero welding or destructive alteration to the vehicle frame, designed to minimize modification footprint. Material: 5053 Aluminum-Magnesium Alloy Known for strong corrosion resistance in wet and muddy off-road conditions. At 5mm minimum plate thickness, it provides the structural rigidity needed to deflect rock strikes and trail debris from the chassis components below. Material Thickness: 5mm minimum Finish: Black Powder-Coat Compatibility: Designed for 2023-2026 Ineos Grenadier Station Wagon Shielded Components: Radiator, front differential, engine oil pan, transfer case, fuel tank, rear differential, rear exhaust pipe Available Configurations Full Set (7PCS) - Protection components: Radiator shield, front differential guard, engine oil pan skid plate, transfer case armor, main fuel tank guard, rear differential guard, rear exhaust pipe plate. Front and Rear Set (2PCS) - Protection components: Radiator shield, rear exhaust pipe plate. Middle Set (5PCS) - Protection components: Front differential guard, engine oil pan skid plate, transfer case armor, main fuel tank guard, rear differential guard. Installation relies on a mechanical bolt-on process utilizing factory frame threads. The procedure involves aligning the individual 5mm minimum 5053 aluminum-magnesium alloy shielding plates with the corresponding chassis crossmember mount points and tightening the supplied hardware. No frame drilling, tapping, or metal modification is performed on the vehicle suspension or bodywork. This component does not interface with any electronic sensors or the factory CAN-bus network. Installation time is approximately sixty minutes using standard garage hand tools. FAQ Q: Does the installation require modifying or drilling into the vehicle frame rails? A: This protective system utilizes the existing pre-drilled threaded factory holes located along the main chassis rails, meaning zero drilling or metal cutting is performed. Q: What is the exact thickness of the material used across all pieces in the kit? A: Every plate in this complete chassis protection kit is manufactured from 5mm minimum 5053 aluminum-magnesium alloy to withstand direct rock impacts. Q: Does this underride guard require any permanent modification to the vehicle frame? A: No permanent modification is required. The guard plates bolt directly into factory pre-drilled chassis holes, leaving the vehicle frame and existing coatings intact. Installation Video