RCGF 60cc RE Rear Exhaust Pipe Petrol/ Engine for RC Airplane
Brand Name :RCGF Material : Metal Model Number : 60ccRE Product features: Strong power and stable operation Performance optimization and fast response Upgraded appearance, dynamic atmosphere UseWaLbrocarburetor UseNSKimported bearings Use CDI professional electronic igniter size Warm tips: The oil needle has been adjusted to the best position when the product leaves the factory. Customers in low altitude plain areas do not need additional adjustment. For use in high altitude or mountainous areas, please slightly adjust the "L / H oil needle" according to the actual use. Please refer to the instructions for the installation, maintenance, running in, starting and other operations of the engine. If you have any questions, you can also consult the customer service. Thank you for your support for our products. Tips for using vvrcrcgf two-stroke aviation model gasoline engine: When installing the engine, be sure to seal the carburetor and exhaust port of the engine to prevent foreign matters from entering the engineThe engine block and piston are damaged, which brings inconvenience to your engine. Vvrcrcgf two stroke aviation model gasoline engine running in standard: Engine running in can be divided into ground running in and flight running in. Only good running in can make the engine give full play to its power,performance and performanceService life, please fully run in the engine after receiving it. Thank you! 1.Running in time: more than 2 hours on the ground and more than 5 hours in flight 2.Speed distribution of running in: idle speed 20%, medium speed 60%, high speed 20% 3.Lubrication ratio of running in: 25:1-30:1 (fully synthetic two-stroke engine oil) 4.Precautions for running in: do not flash oil during running in(the throttle changes too much in a short time), in the process of flight running inTry not to fly with the maximum power for a long time, and keep it below 80%. Pay attention to whether the heat dissipation channel of the engine is smoothGenerally speaking, the propeller used is appropriate. It must be preheated and debugged before flying or debugging.