ESP32-C3 OLED Screwless Terminal Base, Push-in with LiPo Charger

A base for the ESP32-C3 OLED with push-in terminals: bare wire goes in without a screwdriver. The board plugs into the two black sockets in the middle, each of its sixteen holes comes out to its own terminal, and a LiPo connector, charger and power switch are built in. Highlights Push-in terminals. Two blocks of eight 3.5 mm ways, one down each side. Battery power. JST PH 2.0 connector, TP4054 charger and a slide switch. Plug in USB with the switch ON and a cell connected to charge it. Battery monitor. An open solder jumper connects a divider across the cell to GPIO 2, so a sketch can read its own battery level. Two 4.8 mm mounting holes, 16 mm apart. In the box 1 × ESP32-C3 OLED pluggable terminal base, terminal blocks fitted The ESP32-C3 OLED board, the battery and cables are not included. Specifications Terminals: 2 × 8 push-in, 3.5 mm pitch Battery: JST PH 2.0, single 3.7 V lithium cell with a protection circuit Size: 53.1 × 32.5 mm, 14.9 mm tall from the underside Seat the board with its antenna at the power-switch end and its USB-C socket at the battery-connector end.