MAX30102 Optical Pulse Sensor Learning Kit with ESP32 & OLED

Explore optical pulse-waveform data with the MAX30102 Optical Pulse Sensor Learning Kit. A pre-soldered 38-pin ESP32 USB-C board with 4MB flash provides the controller, and the MAX30102 sensor connects to your experimental firmware over I2C. Use the 0.96-inch blue SSD1306 OLED to display your own sample data or project status while learning sensor communication and signal processing. The kit includes a 400-point breadboard and 10cm jumpers for wiring separate components. Assembly and firmware development are required. This is an educational experiment kit, not a device for medical diagnosis or health monitoring.Bundle value: Purchased separately, the included component variants total $32.61. This kit is $26.99, saving $5.62. 1 × pre-soldered 38-pin ESP32 USB-C board with 4MB flash 1 × pre-soldered MAX30102 optical pulse sensor module 1 × 0.96-inch blue SSD1306 I2C OLED display 1 × 400-point solderless breadboard 1 × 120-piece, 10cm jumper wire set: male–male, male–female and female–female This kit is for educational experiments, not medical diagnosis or health monitoring. Wiring and your own firmware are required. A USB-C data cable, computer, power source and enclosure are not included. Measurements depend on your software and setup; no medical accuracy or diagnostic performance is claimed.Read the kit setup guide for assembly planning, required extras and component references.