PRCJ Soft Stands and Riser Blocks

Soft Stand- For Building, Transport and Assembly PLEASE NOTE: These soft stands ship in two different boxes, you may receive one box before the other. Benefits: Provides stable support for jets on bench, worktable or transport Non-slip surface- holds jets from sliding while building or transporting Soft enough to not scratch fine finishes Standard soft foam contour pads fit most jet profiles (supplied U shape) Customizable- trim the foam for a more exact profile (using a serrated kitchen or electric knife) Adjustable footprint- extend the foam pads along the rails to fit almost any size build, transport or assembly need Light weight and easy to handle- less than 3 lbs. Grips well- reposition your build so the top of the fuse is angled towards you for easy access Aligning the rear pad under the wing will stabilize the plane when only one wing panel has been installed Flip the stand over to provide additional height. On many models this will allow an inverted jet to clear the turtle deck Smaller models will have enough clearance for full gear swing. Optional “6” risers” fit underneath stand allowing gear swing on larger jets Easy disassembly for storage or transport Fuel, alcohol and glue resistant Optional “blank” foam blocks allow the builder to customize each pad for an exact fit (with electric knife or serrated kitchen knife). Sizes: Large Stand Small Stand Large wing cradle Small wing cradle Riser blocks Configurations: Set jet right side up for building, storing or transporting Roll jet 45 degrees towards you for easy access into fuse for building Flip jet upside down for easy access to bottom Flip stand over to gain additional height Add option riser blocks to clear gear swing or turtle deck (if inverted) Assembly: Push 2 poles through 1” holes in each of the foam pads Adjust length so the front pad is directly under a former and rear pad is either under a former or under the wing