GripEdge | Ultimate Deep G-FORS Socket Extractor Bundle | Buy XBM10DS & XCM7DS & Get XAM9DS Free
Buy 2, Get 1 Free: The Complete Deep RPT™ Socket Extractor Bundle A standard extractor socket bottoms out on anything that protrudes: a broken stud, an extended lug, a fastener on a long threaded shank. The socket contacts the top of the fastener but cannot seat over its full length, so grip is limited to the exposed head and the extraction load concentrates on a shallow band. These deep-well extractors solve that by adding barrel depth, letting the socket pass over the protrusion and engage the fastener sidewall along a longer span. This bundle delivers that deep-socket capability across the full working range. Pair the XBM10DS 10-Pc 3/8" Drive Metric Deep set with the XCM7DS 7-Pc 1/2" Drive Metric Deep set, and the XAM9DS 9-Pc 1/4" Drive Metric Deep set ships free. Together they provide continuous deep-well metric coverage from 4mm through 25mm across all three common drive sizes, with a single extraction principle behind every socket. Every socket in all three sets is built on the same patented G-FORS™ geometry, so engagement behavior is identical whether you are clearing a protruding 6mm stud or a seized 24mm lug on an extended shank. Nothing in the lineup is a reduced-specification piece. What's in the bundle XBM10DS: 10-Pc 3/8" Drive Metric Deep — Sizes 10-19mm. The primary-range deep set covering the bolt and stud sizes most engine, chassis, and drivetrain work lives in, with the depth to clear protruding threads. XCM7DS: 7-Pc 1/2" Drive Metric Deep — Sizes 19-25mm. Heavier-wall deep sockets rated for the higher breakaway torque of large, corroded, or seized fasteners on extended studs. XAM9DS: 9-Pc 1/4" Drive Metric Deep (FREE) — Sizes 4-12mm. The small-fastener deep range for tight-access and low-torque applications where control matters more than mass. The engineering behind the grip Deep-well barrel for protruding fasteners. The added socket depth allows the extractor to pass over a broken stud, extended lug, or long threaded shank and engage the fastener along its length, rather than gripping only the exposed head. Extraction load spreads over a longer contact span, reducing the tendency to slip on fasteners a standard-depth socket cannot fully seat on. Straight-cut, non-tapered bore. Where tapered extractors contact the fastener at a narrow band and wedge material outward, the G-FORS™ profile is cut straight so its grooves make full-length contact along the fastener sidewall. Load distributes over the entire engagement depth rather than a single point, and the geometry pulls material inward to increase bite as torque rises. The result is reliable purchase on fasteners rounded up to 100%. Integrated G-FORS™ pusher rod. Extraction is only half the job; clearing the socket is the other half. Thread the pusher rod through the rear of the extractor and the extracted stud, bolt, or screw drives straight out. No bench vice, no hammer and punch, no risk to the socket's internal geometry. Bi-directional engagement. The profile grips on both left and right-hand threads, which lets you work a seized fastener back and forth to break the corrosion bond before final removal. A compromised fastener can also be reinstalled temporarily when a replacement is not on hand. Material and finish. Premium Cr-Mo steel construction for the strength and fatigue resistance required under impact, a corrosion-resistant coating, and laser-marked sizing for legibility in low light. Every socket is hand and impact ready. Two sets, three drive sizes, one free, and one extraction principle from the smallest protruding stud to the most stubborn extended lug. When others fail, GRIP IT. For a full breakdown of the extraction geometry, see our G-FORS™ Technology page.