Friction-Fit Flared Magwell for Daewoo

AR mag couplers for use with flared magwells can be found here Flared magwells for additional firearm models can be found here - Easier Mag Insertion: The wide flare on these friction-fit magwells increases the area the mag can be pushed into the magwell by a significant amount. They are designed to precisely align with the existing magwell for a seamless magazine insertion. - Installation: Line up the opening on the back of the magwell with the magwell on your lower and slide it on. There should be some resistance; this is intentional to ensure the magwell stays put during use. Although it should not be necessary, it can also be tapped on gently with a rubber mallet. If it takes more force than this, contact me. - Friction-Fit: Precise design slides tightly on magwell bevel. Due to the exact fit, it will only fit the exact lower models stated in the product title / shown in the product images. - PETG-CF Material: Printed out of higher temp-resistant material than standard PLA+. - Outer Flared Magwell Dimensions: 3.33" x 1.875" x 0.71" - Made in USA: 2500+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints. MATERIAL: 3D printed using PETG-CF filament. WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free. Made in USA. Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.