HDPE Replacement Canopy Top — Direct Drop-In for EHS Steel Canopies | Lightweight, Rust-Proof, Dent-Resistant

Already own one of our steel canopies? This is the upgrade — and the fix — you've been asking for. We built this panel because our own customers kept asking for it. Some of you wanted a lighter top without buying a whole new canopy. Others backed into a low branch, clipped a tree line, or had a top take a beating over a few seasons and just needed to replace the panel — not the entire setup. This HDPE top bolts directly onto the exact same frame and mounting brackets as the EHS steel canopy you already own. There's nothing to modify. Remove the six screws securing your current top, lift it off, set the HDPE panel in its place, and reinstall the same screws. Most folks have it swapped in well under ten minutes with a basic driver. Why HDPE over steel? It's not that one is better than the other — they're different tools for different jobs. Steel is rigid and traditional. HDPE is lightweight, completely rust-proof, and flexes instead of denting when it meets a branch. If you spend time around tree lines, run gates, or just want less weight up top, HDPE earns its keep. And because it can't rust, it holds up to weather and washdowns season after season without corroding at the seams. Two reasons people grab this panel: The upgrade: Lighten your existing rig and gain dent resistance without repurchasing the whole canopy. The replacement: Damaged your top? Swap just the panel for a fraction of a full canopy's cost and get back to work. Ships fully protected and ready to install. No frame, no brackets, no fan included — just the panel, because that's the part you already need. What's Included (1) HDPE replacement canopy top panel Reuses your existing mounting screws and brackets Not included: canopy frame, ROPS clamps/brackets, mounting hardware, fan. This is the panel only — a replacement for the top of a canopy you already own.