SFPADS Reusable Sediment Guards 30-Pack

No unnecessary steps, no complexity, just water care made simple. Your Aquabliss shower filter works in stages. These sediment guards are its first defense. They block dirt, debris, rust and loose particles before they reach the filter media, protecting your filtration system and keeping your water pressure consistent. Replace or rinse them regularly, and your filter keeps doing what it was designed to do. The first line of defense in multi-stage filtration. Sediment is one of the most common causes of reduced filter performance and low water pressure. These guards sit at both ends of your filter cartridge, capturing large suspended particles before they can clog the filtration media inside. Without them, debris can compromise the rest of the filtration process, so keeping them clean is one of the best things you can do for your water. Reusable, rinse-clean and ready when you need them. Unlike single-use alternatives, Aquabliss sediment guards are designed to be rinsed and reused multiple times before replacing. Simply remove, rinse thoroughly with water, and they're ready to go again. When they've reached the end of their life, you have 30 replacements ready. Signs it's time to clean or replace your guards If you notice a drop in water pressure, that's your signal. Reduced flow usually means your sediment guards have done their job and need a rinse or a swap. With 30 guards in the pack, you're covered for well over a year. The easy upgrade your routine needs. Fits in minutes. No tools needed Open the filter housing, remove the cartridge, twist off the end caps, swap the guards at each end, reassemble, and you're done. Our products are made to fit into your life, with straightforward design that makes for accessible installation to all. How to replace your sediment guards: Open the shower filter housing and remove the cartridge Twist the end caps on each end of the cartridge counterclockwise Replace the sediment guard at each end of the cartridge Reassemble the cartridge and place it back inside the filter housing Screw the filter back onto your showerhead, and you’re done USA-Based Customer Care Aquabliss products come with simple instructions and are super easy to install. But if you need more help, you can get in touch with our customer service team. For any questions, comments, or suggestions, reach out to us any time, and we'd be happy to help. FAQs How often should I replace the sediment guards? It depends on your water quality. If you notice a drop in water pressure, it's time to rinse or replace the pads. In areas with higher sediment levels you may need to clean or replace them more frequently. Can the guards be reused? Yes. Rinse them thoroughly under water, and they can be reused multiple times. Replace when rinsing no longer restores your water pressure or flow. 30 guards in the pack means replacements are always on hand. Which filters are these compatible with? These sediment guards are compatible with the Aquabliss shower filter cartridges for Daily Revitalize+ and Daily Essential+ shower filters. Do I need any tools to install them? No tools required. The full installation process takes around two minutes.