Starlink Mini Suction Cup Mount – Quick Release Mount with Vacuum Suction Cups

The Revolink Starlink Mini Suction Cup Mount pairs our Quick Release Mount with three hand-pump vacuum suction cups for a no-drill install on glass, painted metal, fiberglass and other smooth, non-porous surfaces. Swap the dish in and out in under 10 seconds, and pop the whole mount off when you're done. Compatibility Starlink Mini dish Holds on smooth, flat, non-porous surfaces: car and truck roofs, hoods, glass, fiberglass camper shells and truck caps, boat decks Works where magnets won't, including aluminum and fiberglass panels and Bronco hardtops Not for textured, porous, wrapped or heavily curved surfaces Driving While Installed: Hold depends on a clean, smooth, flat surface. Check each cup's indicator before every drive and re-pump if needed. Hand-Pump Vacuum Suction Each cup has a hand pump that pulls a strong vacuum seal against the surface. A built-in indicator shows when it's time to re-pump, so you know the hold is secure at a glance. Tool-Free Quick Release Two cam-lever handles clamp the Starlink Mini between the end brackets. Flip them open and the dish lifts out in under 10 seconds, without touching the suction cups. Built for the Road Powder-coated 5052 aluminum frame with stainless steel hardware. Foam-lined brackets hold the dish without rattling. Frame measures 12 × 8.5 × 2 in (305 × 218 × 53 mm). Easy Setup The suction cups attach to the mount through M6 threaded inserts. Set the mount down on a clean surface, pump each cup and you're ready. What's Included Revolink Quick Release Mount for Starlink Mini 3 Revolink vacuum suction cups with hand pumps and M6 threaded inserts Need power? Add the Starlink Mini USB-C to Barrel Jack Power Cable or the USB Car Charger. Revolink Satellite Gear is an independent accessory manufacturer, not affiliated with SpaceX or Starlink. Starlink Mini dish not included.