ProSoft Technology PLX32-MBTCP-PND Protocol Gateway Module

Configured for bi-directional data conversion in PROFINET and Modbus TCP subnets, the ProSoft Technology PLX32-MBTCP-PND (PLX32-MBTCP-PND Protocol Gateway) provides direct physical/electrical execution. The hardware operates as a standalone PROFINET v2.2 Class A Device while concurrently supporting Modbus TCP Client and Server functionality over two physically isolated Ethernet channels. Internal memory buffers manage mapped I/O data exchanges between separate network segments without requiring intermediate controller polling overhead. Hardware Specifications Parameter Specification Model PLX32-MBTCP-PND Brand ProSoft Technology Origin USA Weight 1.00 lbs Dimensions 13.67 x 5.05 x 11.13 cm (5.38 x 1.99 x 4.38 in) Operating Temp -25 to +70 deg C (-13 to +158 deg F) Power Consumption 24 VDC @ 100 mA (10 to 36 VDC @ 250 mA max) PROFINET Role PROFINET v2.2 Class A Device (Slave) PROFINET I/O Capacity 1440 bytes Input / 1440 bytes Output Modbus TCP Role Client (Master) and Server (Slave) simultaneously Supported Modbus Functions 1, 2, 3, 4, 5, 6, 15, 16, 22, 23 Ethernet Interface 2 x RJ45 (10/100 Base-T, auto-crossover) Mounting Standard 35 mm DIN rail Industrial Protocol Conversion Latencies & Bus Isolation The PLX32-MBTCP-PND utilizes dual independent 10/100 Mbps Ethernet controllers to maintain deterministic protocol conversion latencies across separate subnets. Network traffic on the PROFINET interface does not leak into the Modbus TCP broadcast domain, eliminating network jitter caused by uncontrolled packet flooding. Galvanic isolation on the DC power terminal and Ethernet interfaces prevents ground loop currents from introducing data corruption or hardware failure in high-noise industrial environments. An integrated SD card interface facilitates direct flash memory cloning of gateway configuration profiles, minimizing hardware replacement downtime by allowing immediate parameter restoration without terminal software intervention. Frequently Asked Questions Q: How are isolated subnets maintained across the physical RJ45 interfaces? A: The gateway incorporates two distinct MAC addresses and network interface cards, preventing internal routing or bridged frame forwarding between the Modbus TCP and PROFINET physical ports. Q: What happens to the Modbus TCP network state if the PROFINET PLC enters a stop condition? A: The gateway maintains its internal database values or applies configured fail-safe options to the Modbus registers based on the command timeouts set in the ProSoft Configuration Builder utility. Field Installation Guidelines Mount the module vertically onto a standard 35 mm DIN rail, maintaining a minimum clearance of 50 mm above and below the enclosure for passive convection cooling. Connect the protective earth (PE) terminal directly to the central panel ground bus using a short, low-impedance copper conductor (minimum 14 AWG / 2.5 mm sq). Route DC power wiring through a dedicated 10 to 36 VDC power supply, ensuring wire runs are physically separated from high-voltage motor lead conduits. Insert Cat5e or Cat6 shielded twisted-pair (STP) cables into the RJ45 Ethernet ports, verifying that cable shield drains ground through the RJ45 connector housing. Format the configuration backup SD card using FAT32 before inserting it into the designated module slot prior to initial commissioning.