Dual Pedal Momentary Foot Switch NO Contact Output 4 Core Cable (Model: 0044108)

Package Include: 1 x Dual Pedal Momentary Foot Switch 1 x User Manual Introduction: This is a dual-pedal momentary foot switch with normally open contact output and 4-core cable. Features red and black pedals for different functions, such as "extend" and "retract" or "CW" and "CCW". Each pedal is equipped with a set of normally open contacts. You can connect this dual-pedal momentary foot switch to a receiver with wired control terminals, to controls the clockwise (CW) and counter-clockwise (CCW) rotation of the DC motor, or the extension and retraction of the linear actuator. Product Description: Operating Voltage : DC 12V ~ 24V Maximum Load Current: 6A Two Pedals: Red pedal, Black pedal Work Mode: Momentary Equipped with a 300CM 20AWG four-core cable Each pedal is equipped with a set NO contacts Contact Material: Silver Contacts Operating Temperature: -20°C to +70°C Internal cables are pre-wired Size: 142 x 150 x 34 mm Suitable for our wireless remote control switch kit for DC 12V 24V electric linear actuator, such as Model: 0020512 and Model: 0020317. Suitable for our wireless remote control switch kit for DC 12V 24V electric motor, such as Model: 0020512 and Model: 0020317. Wiring: Connect to the receiver S1FC-DC of the product "Model: 0020317": 1. Connect the positive pole of DC power supply to terminal <+> of the receiver's input, and connect the negative pole of DC power supply to terminal <-> of the receiver's input. 2. Connect the foot switch wires to the receiver's wired control terminals as follows: 1) Brown wire to <UP> terminal 2) Black wire to <DOWN> terminal 3) Blue and white wires to <COM> terminal 3. Connect two wires of the motor or the linear actuator to terminals <Motor> of the receiver, and you can exchange these two wires to change the rotating direction of the motor or the moving direction of the linear actuator. Connect to the receiver S1PF-DC of the product "Model: 0020512": 1. Connect the positive pole of DC power supply to terminal <+> of the receiver's input, and connect the negative pole of DC power supply to terminal <-> of the receiver's input. 2. Connect the foot switch wires to the receiver's wired control terminals as follows: 1) Brown wire to <S1> terminal 2) Black wire to <S2> terminal 3) Blue and white wires to <GND> terminal 3. Connect two wires of the motor or the linear actuator to terminals <Motor> of the receiver, and you can exchange these two wires to change the rotating direction of the motor or the moving direction of the linear actuator. Operation: Step on and hold the red foot pedal, motor rotates in positive direction, or linear actuator extends outward; Release the pedal, motor or linear actuator stops. Step on and hold the black foot pedal, motor rotates in reversal direction, or linear actuator inward retracts; Release the pedal, motor or linear actuator stops.