Side Frames and Top Case Rack for Yamaha Ténéré 700 from 2022 | PIKE TRACKER

Complete three-case rack for the Yamaha Ténéré 700 from 2022 onward: side racks and a top-case rack in a single kit, as indicated by LOBOO. The cases and top case are not included. LOBOO calls it the Three Case Rack, code JP871BW, and states that it is for the PIKE TRACKER and CONQUEROR series. It is not the combination of the JP871B racks and the JP871W top-case rack: the rear section is a single frame connected to the side racks. What you can mount On the sides: the PIKE TRACKER P35L + P30R aluminum cases, in black or silver. The right-hand case has a recess that clears the exhaust. Dimensions and contents are listed on the PIKE TRACKER aluminum cases page. At the rear: the 36- or 45-liter PIKE TRACKER top case, on the PIKE TRACKER top case page. What's included The manual lists 21 items: left and right racks, crossbar, rear frame, top-case plate, front bracket, three pairs of brackets marked left and right (7, 19, and 20), 4 spacers Ø 20 × 18 mm, M6 × 35, M6 × 25, M8 × 30, M8 × 20, and M8 × 25 screws, M6 and M8 washers, two shaped spacers, 15 mm and Ø 20 caps with logo, and threadlocker. How to install it Ten steps: in the first three, the mounting points on both sides of the tail section are cleared and four screws under the seat are removed; then the front bracket, left and right racks, rear frame, spacers, and finally the plate are installed. No drilling is required. There are two torque settings: 12 N·m for the M6 screws and 20 N·m for the M8 screws, using the included threadlocker. LOBOO asks you not to fully tighten anything until you have completed the adjustments. If you only need part of it For the side cases only, there are the JP871B side racks; for the top case only, there is the JP871W top-case plate. For the racks in the LOBOO PIKE TRACKER system, LOBOO specifies stainless steel and aluminum alloy without stating which part is made of which material. Weight and maximum load are not specified.