Climate Control Knobs - S2000 (00-09) - Aluminum

Aluminum Climate Control Knobs A direct-replacement upgrade for the factory plastic units that commonly fade, discolor, and wear over time. Engineered for all 1999–2009 S2000 models, these aluminum knobs immediately elevate the tactile feel and visual refinement of the cockpit with a clean, motorsport-inspired finish. Refined Illumination The integrated indicator marker is designed to allow light transfer, replicating original functionality for clear visibility and accurate adjustment in low-light conditions. Enhanced Durability Unlike aging plastic, these aluminum components resist deformation and surface degradation, maintaining their structural integrity and finish over the long term. Pre-Shipment Fitment Every set of climate control knobs is individually test-fitted before packaging. This allows us to verify the fitment and engagement of the mounting tabs prior to shipment. Fitment & Installation Protocol Cavity Inspection Age and environmental exposure can cause dirt, residue, and debris to accumulate inside the factory control unit cavity. Inspect the control shaft and cavity before installation and ensure the area is clean. Tight Fit Adjustment If the knob is excessively tight on your vehicle, use a 5mm Allen wrench to carefully and slightly widen the mounting tabs. Make only small adjustments and test the fit frequently. Do not force the knob onto the control shaft. Loose Fit Adjustment If the knob is too loose on your vehicle, use pliers to gently tighten the mounting tabs. Make small adjustments based on the fit of your individual vehicle and test the knob after each adjustment. Important Fitment Notice All climate control knobs are individually test-fitted before they are packaged and shipped. However, variations in the condition, age, wear, and dimensions of the factory climate control assembly may affect the final fit on your vehicle. Minor adjustment may be required for proper fitment. If the knobs are too tight, carefully widen the mounting tabs using a 5mm Allen wrench. If the knobs are too loose, gently tighten the tabs with pliers. Adjust gradually and test the fit frequently. Do not force, over-expand, bend, or otherwise excessively manipulate the mounting tabs. Damage caused by improper installation, excessive force, over-adjustment, or other negligence is not covered by MITA Motorsports. Broken mounting tabs resulting from customer adjustment or installation are not eligible for replacement. If the tabs are damaged, a new set of knobs must be purchased.