Whirlpool Range Control Board W10904904 — Fix Oven That Won't Heat, Error Codes, or Dead Controls

OEM REPLACEMENT PART Whirlpool Range Control Board W10904904 Part# W10904904 Fits Whirlpool Fits Maytag Electric Range / Oven Whirlpool Range Oven Not Heating, Showing Error Codes, or Controls Dead? Range Control Board W10904904 – Fix It Fast A Whirlpool range oven that won't heat, displays persistent error codes, or has completely unresponsive controls almost always has a failed range control board. In most Whirlpool and Maytag electric ranges, the control board is the central brain managing oven temperature, bake and broil element activation, the clock, and all touchpad inputs. When it fails, the oven stops heating, F-codes appear that won't clear after a power reset, or the entire control panel goes dark or erratic — even though the range top burners may still work. ⚡ One of the most common electronic failures in Whirlpool-built electric ranges. Part W10904904 is the genuine OEM replacement that restores full oven operation, clears persistent error codes, and returns all controls to normal function immediately. ❓ Is This the Right Part? This is the correct fix if ALL of the following are true: ✔ Range has power — clock or display shows something (even an error code) ✔ Surface burners work normally (rules out a main power supply issue) ✔ Bake and broil elements have been tested and confirmed not open/burned out ✔ ONLY problem is the oven not heating, persistent F-codes that return after a power reset, or a completely unresponsive or erratic touchpad Not sure? Send us your model number — we'll confirm before you order. 🔧 Common Symptoms Oven does not heat on bake or broil despite elements testing OK Persistent F-code error (F2, F3, F5, F9, etc.) that returns after power reset Touchpad controls completely unresponsive, randomly activating, or locked up Oven overheats or runs continuously without shutting off at setpoint Display blank, flickering, or showing garbled characters Oven door locks unexpectedly and won't release ✔ If these symptoms match, this is the most likely failed component in the system. ✔ In most cases, replacing this range control board restores full oven operation and clears all error codes immediately. 📦 Part Details Part Number: W10904904 Type: Electric Range Control Board (ERC / Electronic Range Control) Brands: Whirlpool, Maytag, KitchenAid, Amana OEM: Genuine Whirlpool replacement part ⚠️ Recommended While Repairing: Before replacing the control board, test the oven temperature sensor (RTD probe). A shorted or open temperature sensor causes F2/F3 error codes that mimic a failed board — and a new board installed with a bad sensor will fail again quickly. The sensor should read approximately 1080Ω at room temperature with a multimeter. If it's out of spec, replace it at the same time. ⚙️ Installation Skill Level: Moderate — 30–45 minutes. Disconnect power at the breaker before servicing. Access the control board by removing the back panel or console depending on your model, photograph all wire harness connections before disconnecting, transfer any mounting hardware to the new board, reconnect all harnesses in the correct positions, and reassemble. Restore power and run a bake cycle to confirm normal operation and verify no error codes return. ✓ Compatible Models Confirmed compatible with select Whirlpool, Maytag, KitchenAid, and Amana electric range models. Contact us to verify your model number before ordering. 💡 Pro Tip Photograph Every Connector Before You Disconnect Anything: Whirlpool range control boards have multiple wire harness connectors that look similar but are not interchangeable. Before removing a single connector, take a clear photo of the full board showing all harness positions. This takes 30 seconds and eliminates the most common installation error — a misrouted connector that causes the new board to display the same error codes as the old one.