SPEEDYRJ45 PXSPDY6e Feedthrough Style Cat6 RJ45 Plug for Unscreened Cable

SPEEDYRJ45 PXSPDY6e Feedthrough Style Cat6 RJ45 Plug for Unscreened Cable are designed to simplify twisted pair terminations by allowing the wire pairs to be easily inserted through the plug and out of the front. This allows the installer to easily check the wiring order before crimping the connector. Twist is maintained more easily enabling a better performing crimp. Waste is minimised and the plugs are suitable for either stranded or solid wires. Features Allows Category 6 twisted pair wires to be inserted through the body and pulled out of the front to ensure the correct wiring order before crimping By pulling the cores into the plug, twists can easily be maintained up to the contacts, enabling fully rated category performance Contact blades are suitable for stranded or solid wire cores from 22‐26 AWG (0.65 – 0.40mm), with insulation up to 0.98 ± 0.04mm O.D Perfect solution for rapid termination Suitable for termination of solid or stranded UTP cables with sheath O.D. of 5.0 – 6.5mm Faults and failures minimised Simple one-piece design Less cable scrap and wastage N.B. Must be used with suitable crimp tool i.e. TRCSPDY, TRCSPDY2, TRCSPDY4, TRCSPDY5 Designed for use with transparent and coloured flush strain relief boots (PS6*) Specifications Materials: Housing: Polycarbonate UL94-V0 Contact pin: 50”μ/1.27 μm gold plating over nickel over phosphor bronze Electrical: Contact resistance: 30milliΩ max. Insulation resistance: DC 300V, 100 MegaΩ min. Dielectric withstanding voltage: 300V AC for one minute Mechanical: Working temperature: -25-55˚C Durability: 1000 mating cycles min. Tensile strength between plug and jack is higher than 7.7kgf Packaging: Supplied in polybags of 10 then 100 then 500. Also available in bulk – in poly bag of 200 or in handy transparent plastic screw top pot of 100 Documentation Datasheet: PXSPDY6e specification sheet (002)