MJJC Hurricane Air Foam Gun

MJJC Hurricane Air Foam Gun | Automize Compressor-Powered Foam. No Pressure Washer Needed. The MJJC Hurricane Air Foam Gun connects to your air compressor to produce thick, clinging snow foam from any shampoo or pre-wash — a proper touchless foam pre-soak stage without a pressure washer in sight. Most foam cannons need a pressure washer to function. This one runs off your compressor at 60–90 PSI — which means if you already have a compressor in the garage, you're one gun away from a full clinging foam pre-soak before your contact wash. The foam is light and airy enough to grip vertical surfaces and stay put while it dwells, softening grit and dirt before the mitt ever touches the paint. A foam layer between your mitt and the paint is one of the most effective swirl-prevention tools in a wash routine, and this gun adds that stage to any garage setup. Compressor-Powered — No Pressure Washer Connects directly to an air compressor via standard airline fitting. If you already have a compressor set up in the garage — paired with the Dera DK-50L for example — this gun slots straight into your existing setup. Thick, Clinging Foam Air pressure converts shampoo into light, airy foam that clings to vertical surfaces without running off — giving the product dwell time to soften and loosen dirt before you make contact with the paint. Works With Any Shampoo or Pre-Wash Fill with your preferred diluted shampoo, pre-wash concentrate, or APC and the gun does the rest. Compatible with CarPro Lift, Reset, or any other foamable detailing chemical. Touchless Pre-Soak Stage Apply foam before the mitt touches the car — the foam layer lubricates the surface, encapsulates loose dirt, and reduces the amount of grit being dragged across the paint during the contact wash. 🛠️ How to Use 1 Fill & Connect Fill the bottle with a diluted shampoo or pre-wash solution. Connect the gun to your air compressor airline — ensure your compressor is set to between 60 and 90 PSI before triggering the gun. 2 Foam the Car Work top-down, applying an even coat of foam across all panels. Allow the foam to dwell for a few minutes — do not let it dry on the surface. The foam will begin to encapsulate and soften surface grime. 3 Rinse & Wash Rinse the foam off thoroughly, then proceed with your standard two-bucket contact wash. The contact wash now has significantly less contamination to deal with — less grit dragged across the paint, less chance of swirls. Quick Reference Power Source Air compressor (not a pressure washer) Required Air Pressure 60–90 PSI (4–6 bar) Connection Standard airline fitting Compatible With Any foamable shampoo, pre-wash, or APC dilution Pairs With Dera DK-50L Air Compressor (available at Automize) This gun requires an air compressor operating at 60–90 PSI — it is not compatible with pressure washers. Do not exceed 90 PSI. Always dilute chemicals before adding to the bottle. Do not let foam dry on the paint surface — rinse within a few minutes of application. Foam before the mitt. Every wash, every time. Order now for quick delivery all over Pakistan.