Single-Sided Glass Fibre Feather Flag with 10.5kg Square Plate Base inc. Graphic Printing - 5m

A single-sided print places the design on the front of the polyester only. Because the fabric is one layer, light brings a softened, mirror-image version through to the back. Where the blade stands against a wall, a stand panel or a window, the front is the only side an onlooker reads, so a single print delivers the same towering impact for less than covering both faces would cost. Unlike a rounded sail, the feather is a tall, tapering blade. Its straight leading edge sleeves over the pole, and a curved whip at the top draws the trailing edge out so a five-metre blade holds a clean, upright line. Held that way the front graphic stays open and readable in the still air of a hall, where a loose banner would fall flat against the pole. The mast is glass fibre, thin glass filaments set in resin for a tall, springy pole, tipped with a GRP whip that bends in a draught. The inner pole diameter stays 16.8mm across the range, so fittings interchange between flags. Underneath the blade, a square steel plate does the standing by weight alone. It lies flat on the floor and the pole drops into a central socket, so the base mass keeps the full height upright with nothing drilled, staked in or parked on top. The hold is purely weight on a level surface, so it belongs on hard floors indoors or under cover; grass needs a ground spike, and a forecourt needs a drive-on car base. Colour is set by dye sublimation, a heat process that vaporises the inks and forces them into the polyester so they dye the cloth rather than coat it. Printed that way the front keeps its colour under hall lighting and rolls away between uses without flaking. The front face is printed across an area of 690mm by 3860mm, a tall column that suits the full-height blade. Supply the artwork, we print the front, and the flag goes up by hand in about two minutes. What Ships in Your Pack 1 x 5m single-sided glass fibre feather flag, printed on the front face from your artwork 1 x 10.5kg square steel plate base 1 x carry bag Dressing Halls or Shows Across Sites? We print and supply feather flags in volume for exhibition teams, event organisers, retail groups and venue fit-outs across the UK. For a matched set of tall single-sided flags across halls or shows, or repeat artwork to a campaign calendar, the team can quote the run and turn it round to your dates. Tell us the job: call 01279460460 or send your brief and we will reply with a plan. FF5000SF is a 5m single-sided glass fibre feather flag from Displaysense, the tallest feather in the range, supplied with a 10.5kg square steel plate base and printing on one face. Its differentiator is a towering vertical blade with a single printed face for one-direction viewing, held standing by a weighted plate and no stake or vehicle. Height 5010mm, width 690mm. Base weight 10.5kg. A printed graphic of 690mm x 3860mm sits on the front face, with a soft mirror image showing through to the back. Built around a glass fibre pole with a GRP whip curving the top, a polyester flag and a steel plate base; inner pole diameter 16.8mm. Endures winds to 45 kph (28 mph), Beaufort Scale 6. Lifted into place by hand in about two minutes, with a carry bag and a 1 year guarantee in the box. Suited to large halls, double-height atriums, exhibition aisles, tall foyers and high glazed fronts. A double-sided version, plus a ground spike base for grass and a drive-on car base for forecourts, are also available. Displaysense, UK display product specialists since 1978.