KONGZEE 12-Pack TENS Unit Replacement Pads | Universal 2mm Electrodes

Short answer: KONGZEE TENS unit replacement pads fit compatible TENS and EMS devices that use a standard 2mm pin connector. Each pack contains 12 reusable, self-adhesive electrodes in mixed sizes. Check the connector on your current lead wire before ordering because snap, proprietary and differently sized connectors will not fit.Compatibility Checklist Check Required for Compatibility Connector Standard 2mm pin or pigtail connection Device TENS or EMS unit with compatible removable lead wires Not compatible with Snap-only, proprietary or differently sized connectors Brand name alone does not guarantee compatibility. Compare the metal pin and connector opening with your current pads or device manual.What's Included Quantity: 12 pads (6 pairs) Connector: Standard 2mm pin Pad type: Self-adhesive and reusable Sizes: Mixed shapes and sizes for smaller and broader areas Construction: Conductive gel with flexible non-woven backing Latex-free: Yes How to Apply TENS Pads Switch the TENS unit off before connecting, applying or moving pads. Clean and completely dry the skin. Do not apply lotion, oil, powder or cream. Press the full gel surface onto intact skin so the edges do not lift. Keep pads separated and follow your device manual or clinician's placement instructions. Start at the lowest intensity and increase gradually until the sensation is strong but comfortable, never painful. Use the TENS unit pad placement chart and safety guide for general lower-back, shoulder, knee and limb guidance.Why TENS Pads Stop StickingSkin oil, lotion, dust, repeated touching and normal gel wear reduce adhesion. Better preparation and storage can extend pad life, but worn pads cannot be restored indefinitely. Read how to clean TENS unit pads and make them sticky again before using water or replacing a pad.Pad Care and Storage Handle each pad by its edge rather than touching the gel. Return pads to the original plastic backing immediately after use. Seal them in their storage bag away from dust, heat and direct sunlight. Follow the pad manufacturer's cleaning instructions; do not use alcohol, soap, oil or household cleaner on the conductive gel. Do not share used pads between people. When to Replace TENS PadsReplace a pad when it is torn, permanently dry, contaminated, no longer adheres across the full surface or produces uneven, sharp or uncomfortable stimulation. Stop using the device if skin becomes irritated. Use the replacement TENS pads compatibility guide to compare connector types, sizes and replacement signs.Frequently Asked QuestionsAre these universal TENS unit pads?They are compatible with many devices that use the common 2mm pin connector, but they are not compatible with every TENS unit. Verify the connector type before ordering.Can I clean reusable TENS pads?Some reusable hydrogel pads can be lightly refreshed with water, but instructions vary. Follow the pad and device manual, never soak the connector, and replace damaged or contaminated pads.How do I make TENS pads sticky again?Start with clean, dry skin and correct storage. If the manufacturer permits it, lightly moistening the gel surface with clean water may temporarily improve adhesion. A pad that still lifts or causes uneven stimulation should be replaced.How long do TENS pads last?Pad life varies with skin preparation, storage, environment and frequency of use. Inspect adhesion and gel condition before every session instead of relying on a fixed number of uses.Can two people share the same pads?No. Reusable electrode pads should be assigned to one person for hygiene and consistent adhesion.Where can I find compatible lead wires?KONGZEE also offers standard 2mm TENS replacement lead wires. Confirm both the device-side plug and pad-side pin before ordering.