RotopaX Mount Tubular Clamps

Built for Tubular Roof Racks The GZila RotopaX Tubular Clamp Mount gives you a clean way to mount RotopaX cans to compatible tubular roof racks. Designed for round tube applications, these mounts let you position your RotopaX setup where it works best for your rack, vehicle, and gear layout. Wide Diameter Range Available in multiple diameter options to fit a variety of round tubular roof racks. RotopaX Mount Ready Works with RotopaX mounts and smaller cans using the single mounting hole layout. Made In-House Machined from USA-made aluminum and finished in black anodizing. Fitment Compatible With Compatible tubular roof racks Round tube rack sections matching the selected clamp size RotopaX mounts and smaller RotopaX cans Many off-road, overland, and utility rack setups Important Notes Measure your rack tubing before ordering RotopaX mount and cans are not included Larger 4-gallon cans may require additional mounts RTT clearance may vary by rack, vehicle, and tent setup What's Included RotopaX Mount Plate Machined aluminum mounting plate Tubular Clamp Set Clamp size based on selected option Black Anodized Finish Clean, durable aluminum finish Before Ordering 1. Measure your rack tubing Use calipers or our printable measuring PDF to confirm your tube diameter before selecting a clamp size. 2. Select the matching clamp size Choose the clamp size that matches your actual roof rack tubing. A slightly oversized reading is normal on powder coated racks, so a 1.75" clamp may be correct even if your rack measures slightly over 1.75". Common reference sizes: 4Runner TRD Pro 2019–2024, FJ Cruiser 2007-2014, and Sequoia TRD Pro 2020–2022 roof racks typically use 1.75" tubing. GOBI Toyota roof racks typically use 1.00" tubing. 3. Check tent and accessory clearance Verify that your rooftop tent, awning, crossbars, and other accessories will clear the RotopaX can once installed. Installation 1. Position the clamps Place the clamp halves around the tubing and position them where you want the RotopaX mount installed. 2. Tighten the clamps evenly Gradually tighten all hardware a little at a time so the clamps seat evenly around the tubing. 3. Attach the RotopaX mount Install your RotopaX mount using the supplied hardware and adjust as needed before final tightening. 4. Install your RotopaX can Secure your RotopaX can according to the RotopaX mount manufacturer's instructions. Installation is simple with basic hand tools. Periodically check and tighten hardware after off-road use or long trips.