Saber SharkBite Quick Connect Automatic Tyre Deflators (4 Pack)

Saber SharkBite Quick Connect Automatic Tyre Deflators (4 Pack) Air down faster and spend less time crouched next to your tyres. The SharkBite kit gives you four automatic deflators that push straight onto the tyre valve, with none of the winding on and off you get with a screw-on deflator. Set each one to the pressure you want, clip one onto each tyre, and get on with the rest of the setup while all four air down together. The preset is mechanical and adjustable. Once you have found the setting that suits your vehicle and the ground you drive, it becomes a repeatable starting point for the next trip. Tyre temperature, valve condition and normal tolerances all affect where a deflator stops, so check the final pressure with a proper gauge before driving off. The set packs into a fitted hard case, so the four small deflators stay together in the drawer or recovery bag between trips. Features Push-on connection. No screwing on and off, so you are done faster at both ends of the job. Four deflators in the kit, one per tyre, all airing down at the same time. Adjustable preset with clear markings, so setting up for the beach or the tracks is not guesswork. Works on its own once connected. Sort the recovery gear, the passengers or the vehicle while it runs. Small enough to live permanently in a recovery bag, drawer system or glovebox. Fitted hard case keeps the set together and protected. In the box 4 x Saber SharkBite Quick Connect Tyre Deflators 1 x Hard storage case Where you will use them Beach and sand, dirt roads, corrugations, mud, and general 4WD touring. Anywhere you drop pressures before leaving the bitumen. Before you drive Pull each deflator off. Check every tyre with a reliable gauge and adjust individual tyres where needed. Reinflate to the correct road pressure before you are back on sealed roads. The preset markings are a guide to where the deflator should stop; they are not a substitute for a gauge. FAQ How do SharkBite deflators work? Set the pressure on each one, push it onto the tyre valve and it releases air on its own until it reaches the setting. Can I use all four at the same time? Yes. One per tyre, all at once. Why quick connect rather than screw-on? You are not winding a deflator on and off every valve. Fitting and removal takes seconds. Do I still need a tyre gauge? Yes. Confirm the final pressure with a gauge every time before you drive. Can I leave them set? Yes. Once you have a setting that works for your vehicle and terrain, leave it there. Still check the final pressure each time.