BMG Clone Extruder Kit (Two Trees) — BMG Internals + Push-Fit Fittings + PTFE 300 mm + White PTFE 2 mm × 1.5 m

Two Trees BMG clone internals plus the fittings, collets, extruder liner and tube that complete the filament path. One bag for a BMG-style extruder rebuild or a new toolhead. What's in the kit 1× Two Trees BMG clone internals kit — stainless dual-drive gears, white 50T reduction gear, shafts, needle bearings, spring and thumbscrew 1× PC4-M10 push-fit fitting, black collar — the extruder-side coupler for 4 mm tube 2× ECAS04 embedded collet with blue release caps — the toolhead-side tube sockets 2× orange collet clips — lock the tube against back-out 1× PTFE tube, 2 mm ID × 4 mm OD, 300 mm — the extruder liner: cut it to length for the filament path inside the extruder body. Not every extruder uses a liner, but having it in the bag is what makes this a kit. 1× white PTFE tube, 2 mm ID × 4 mm OD, 1.5 m — the feed / reverse-bowden run Which tube White PTFE, 2 mm bore × 1.5 m — the tight bore — constrained guidance for short, straight feed runs and direct-drive setups where the filament must not snake. The liner is always 2 mm. Other bores: 2.5 mm or 3 mm; or the same kit with clear FEP or black PTFE. Fits Any BMG-style dual-drive extruder body — Voron Clockwork, Afterburner and Mini Afterburner builds and the many printed BMG clones; 1.75 mm filament, 4 mm OD tube. Abrasives? The same kits with Runice RNC-coated internals. Gotchas No extruder housing, motor, hotend or fasteners — this is the internals and the filament path. ECAS04 needs a housing pocket cut for the embedded collet; the PC4-M10 needs an M10 port. Same parts, same shelf as the singles linked above — if the kit reads sold out, one of its parts is.