DESCRIPTION. - Quick setting and curing time. - Easy and quick use. - Suitable for dry fastening. - Suitable for wall and overhead application. - Reduced anchor spacing and edge distance. - Variety of cartridge sizes are available. - Partially used cartridges can re-used by replacing the mixer nozzle. - Good resistance to acid and alkali - High durability - Can be used with wet concrete (Reduction of recommended loads of about 20%-40%). GU-2000 STATIC MIXER #817 GOOD USE HARDWARE CO., LTD. GU-2000 P1/7 VINYLESTER INJECTION MORTAR Date of Issue: December 25, 2020 GU-2000 TECHNICAL DATA SHEET ATTENTION - Do not install anchors when substrate temperature is less than 0℃. - Do not install anchors when the GU-2000 mortar temperature is less than 15℃. - AT temperatures below 15℃ GU-2000 should be warmed or stored in temperatures of 20-25℃ for 24hours prior to use to improve product flow and cure. - If the gelling time expires, please use a new static mixer. - Do not cut or shorten nozzles. - If the cartridge is not finished, please clean the opening, then put the plug back and cap tightly. - It can be used again in the future by replacing the static mixer. - Please ensure hole is properly cleaned. Hole may be damp but must be free from water. - Do not dilute mortar with any solvents and/or other chemicals. - Not suitable for use in diamond cored holes without roughening. - Please ensure spiral mixer in nozzles. - Do not install into uncured concrete. - Please use Good Use nozzles, other nozzles may cause ineffective mixing and reduce the properties of the mortar. STORAGE/SHELF LIFE - 18 months if stored in perfect condition. - Avoid direct sunlight. - This product should be stored between +5℃~+25℃ PACKAGING INFORMATION - Each cartridge is packed in plastic bag with 1 static mixer #817