Holybro Remote ID

Holybro Remote ID Holybro Remote ID is a crucial device designed to meet FAA and global regulations for unmanned aircraft systems (UAS). This lightweight and compact module enables drones to broadcast their identification and location information, ensuring compliance with Remote ID requirements. This system seamlessly integrates with Holybro's flight controllers and other components, allowing drone operators to transmit flight data in real-time, such as the drone’s location, operator information, and altitude. The Holybro Remote ID device is an essential component for both commercial and recreational drone pilots aiming to comply with regulations and ensure safe drone operations in shared airspace. Ideal for drone enthusiasts, commercial operators, and organizations that require efficient fleet management, the Holybro Remote ID offers a simple, reliable solution for regulatory compliance. Key Features: FAA-Compliant Remote ID: Ensures compliance with UAS regulations. Lightweight & Compact: Minimal impact on drone performance and flight time. Seamless Integration: Works with a variety of flight controllers and drone platforms. Real-Time Data Broadcast: Transmits essential flight information, ensuring safety and compliance. Overview Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module. The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators. Note: This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. For the most accurate and latest information related to this topic, please refer to the official governance website of your country. If you need customization or have special request, feel free to reach out to us via email. Specification Radio module: Espressif ESP-C3 module Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW) FCC & CE certified radio module Firmware: ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID). Supports upgrading firmware via the web interface (“OTA”) Supported in PX4 & Ardupilot (More Info) Protocol: CAN & Serial Interface: 1x JST GH 4-pin CAN (CAN) port 1x JST GH 6-pin TELEM (UART) port Antenna Connector type: On CNC Case: SMA connector On PCB: IPEX Connector Range: > 5km detection range* Power: 5V supplied from TELEM or CAN port LED lights: Bright RGB status LED Size: Without case: 35.3 x 23.5 mm (not including antenna) With CNC case: 38 x 26.5 x 11.5 mm (not including antenna) Mount: M2 screws Operating temperature: -40°C to +85°C Weight: PCB only: 4 g With CNC case & Antenna: 27.5g Without case & Antenna: 16.5g (Cable 20cm) Certification: FCC& CE * The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible. Guides & Reference Link Holybro Doc Setup & Configuration Guide Firmware Update Guide Firmware support Ardupilot Ardupilot Wiki - RemoteID Ardupilot Wiki - OpenDroneID FW building PX4 PX4 Guide on Remote ID/OpenDroneID PINMAP Package Includes： 1x Remote ID 1x Antenna 1x JST GH 6pin 150mm Cable 1x JST GH 4pin 150mm Cable