P17 Handlebar

Why do you want it? You are looking for a narrow handlebar that allows you to get into that aero position up top while retaining control for descending in the drops. You also might be using a bike with fully integrated cable routing that doesn't allow you to go as low as you would like--a frequent problem for shorter riders on gravel bikes with clearance for big tires. What is it? It's a 240g carbon handlebar primarily designed with gravel racing in mind; but it can also be used for road bikes. The bar features the following measurements and only comes in one size: ~31mm c-c at the tops and 32mm c-c at the clamping area of the hoods, flaring out to 376mm C-C where your hands rest in the drops 100mm of reach (c-c from the clamping area) and are 105mm deep. This gives you the length to sustainably hold an aero hoods position, while moving the drops up 5-10mm for increased control Tops are up to 60mm deep and feature an aero-shaped top profile with a flat top for comfort. The bars sweep back to enable as ergonomic a grip as possible on the tops, given the deep profile Ramps are also shaped to be flat and dropped by 17mm to provide a lower effective stack height for gravel racing This allows you to find a comfortable, narrow, aero position with plenty of surface area to support your hands and wrists, while providing superb descending control in the drops. The bar uses an integrated computer mount that allows for angle adjustability while avoiding mounts on the stem, meaning this bar can be used with most stems that fit 31.8mm bars. A mount that fits Garmin / Wahoo computers and a light/aero sensor are included with the purchase of this bar. This mount uses titanium hardware. The bar can be set up to be UCI road legal, as tested with SRAM AXS E1 levers. This bar is patent pending. How is it Made? The bars are made by a trusted carbon manufacturing partner in China. True to their gravel-racing-based design intent, these bars exceed both ISO 4210 and TBIS 4210 standards for road and mountain bike handlebars. These computer mounts are printed in the USA using HP MJF machines and Nylon PA12 material. Titanium hardware may be sourced from multiple countries. Note: This product is not yet available to order. We are finalizing production models and expect to start fulfilling orders at the end of April or the beginning of May. Pricing is subject to change.