UT3G "Monolith" eGPU Dock Chassis | Premium Open-Frame Enclosure

Please Note: Currently shipping in about 2-weeks from ordering due to high demand! Crafting Solutions, One Layer at a Time – Made in Wylie, TX by Zephyr’s Market Based entirely on the premium "Monolith" design specification, the Monolith is a complete rethink of the standard external GPU enclosure. Rather than treating the bare board as a problem to hide, the Monolith acts as a low, wide, dense-looking architectural plinth for your graphics card to stand on. By keeping the GPU and power supply in free air, this dock delivers flawless thermals and allows a single SKU to fit nearly any graphics card footprint. Why Choose the Monolith? Zero GPU Sag & PC-Grade Support: The heavy-duty structural spine holds your card exactly like a PC case's rear rail. The GPU bracket tab presses against the mounting face and locks in securely with a horizontal knurled M3 thumbscrew. Unrestricted Thermals: The ASM2464PD controller heatsink passes completely through an accent-framed window in the deck. Five precise intake slots in the floor feed the heatsink from below, while your GPU's own fans blow cooling air directly onto it from above. No Clicks, No Rattles: The flush deck is held seamlessly by eight pairs of concealed magnets and lifts easily using a built-in finger scallop. The GPU rests securely on a 1.2 mm protruding TPU grip strip within a sculpted fin cradle, meaning your card is held by vibration-dampening rubber instead of hard plastic. Smart Cable Routing & Strain Relief: The thick right-angle 24-pin ATX plug seats straight into a dedicated 62 mm power bay, allowing the stiff harness to exit cleanly out the back without bending. The USB-C port is protected by a chamfered 22 × 10 mm bezel designed specifically to accommodate thick Thunderbolt 4/5 overmolds. Your USB4 cable runs securely along an internal channel and exits through a flexible TPU grommet. Instant Visual Feedback: Five internal board LEDs are routed flush to the top surface through a custom clear light pipe, allowing you to monitor the safe-shutdown sequence without ever touching the deck. Individual finger windows provide clean access to the switches and jumpers, complete with inlaid accent legends. Multi-Material Industrial Construction The Plinth & Deck: 3D printed in matte ASA (or PETG) to provide high heat resistance (HDT ~95 °C) and prevent plastic creep next to a hot GPU backplate. The Structural Spine: Printed flat on its back using ultra-rigid Carbon-Fiber PETG (PETG-CF) or PA-CF to ensure continuous layer strength along the load paths. Premium Stance: Anchored by four 20 mm TPU 95A rubber feet planted on an 11 mm wide stance shelf to guarantee an incredibly stable, low-mass footprint.