GE DS200SLCCG3AEF Top Communication Board

The GE DS200SLCCG3AEF, also cataloged as the DS200SLCCG3AEF Top Communication Board, operates as a dedicated hardware component for data link processing and signal propagation within Mark V control system platforms. Hardware Specifications Parameter Specification Model DS200SLCCG3AEF Brand General Electric Origin USA Weight 0.24 kg Dimensions 18.8 x 4.2 x 2 cm Operating Temp 0 to 60 deg C Power Consumption 5 W Board Type Top Communication Board Profinet / EtherNet/IP deterministic networks The DS200SLCCG3AEF facilitates high-speed data exchange required for deterministic network communication within the control architecture. It handles the backplane bus synchronization and maintains the integrity of transmitted frames across the Mark V platform. The board interfaces with the host processor to ensure timing constraints are met during command execution, supporting the communication throughput required for complex distributed I/O scanning and status monitoring. Frequently Asked Questions Q: Does the DS200SLCCG3AEF support field-level hot-swap capabilities while the rack is powered? A: No. Power must be removed from the rack assembly before removing or installing this communication board to prevent backplane bus surges or data corruption. Q: How should the interface cables be routed to ensure signal integrity? A: Communication cables must be routed through dedicated shielded conduits, maintaining a minimum separation distance of 150 mm from high-voltage AC power lines to minimize electromagnetic interference. Field Installation Guidelines Ensure the control rack is isolated from the main power supply and verify all energy sources are de-energized. Align the board with the specified guide rails in the designated slot, ensuring the backplane connector pins are perpendicular to the mating receptacle. Apply uniform pressure to the board extraction/insertion levers until the board is fully seated. Secure the faceplate screws to the rack frame to establish proper chassis ground contact. Inspect the status LEDs upon power-up to confirm the module has passed the internal power-on self-test (POST).