Travis CYMA service

Labor $250 plus parts necessary real deal cnc bushings $14 Real Deal 75% cylinder $10 Real Deal V2 Selector Plate $6 Real Deal Delay Chip $5 total $285 1.5 joules 33 RPS also if you need to reduce your FPS to pass chrono, just increase hop a little bit your shooting like 1.52 by adding more hop youl drop under 1.5 What Real Did to restore order 1 - Must use Black O ring for this FPS range, swapped o ring out for the black one 2- Excess Magnets were stuck to the clicker unit, removed magnets and re tuned clicker 3- Clicker tuning consists of adjusting the pre tavel screw to get it closer to your trigger for a small 2 stage trigger as well as adjusting the weight of the break via adjustment screw hidden in the clicker unit 4- Adjusted the Clicker Pro safety lever 5- Never use stock bearings and bushingss, they came undone and one of the shit bearings blew. i Installed Real Deal CNC Steel Bushings and bonded them with a special metal glue 6- Re shimmed entire gun, and THREADLOCKED motor height adjustment screw 7- In order to achieve 1.5 joules we needed proper air volume installed a Real Deal 75% steel cylinder. The stock one was about a 65% cylinder 8- Real Deal Selector Plate for proper function with perun hybrid x cyma gearbox 9- Slight RPM reduction on the motor, max speed is too fast 10- Installed a Delay chip because builds over 31 RPS absolutely need it to feed. 11- Trimmed Tappet Plate to release by the last 3-4 teeth on piston 12- Heat shrink was left on the motor tabs, this is a big NO NO. I removed the heat shrink off the tabs 13- hop chamber required slight spacing, we used a hop chamber spacer 14- Modified buffer tube so that it doesn't clip the wiring Swapped your maple leaf bucking for 4UAD .. significant performance boost