LaVanture Trailer Gas Struts - 85 lb Force - Black Nitride 8mm Rod (LGP8-244-85)

Gas Spring / Lift Support / Black Nitride Strut LaVanture Trailer Gas Struts - 85 lb Force - Black Nitride 8mm Rod Replacement LaVanture gas spring for matching lift-support applications requiring an approx. 2.44" pinhole-to-pinhole length, approx. 8.5" stroke, 8 mm rod diameter, and 85 lb force rating. SKU: LGP8-244-85 1 Gas Strut Included 244-85 / 85 lb Force Approx. 2.44" Pinhole-to-Pinhole / 8.5" Stroke Key Measurements & Specs Specification Detail Part Number / SKU LGP8-244-85 / 244-85 Brand LaVanture Product Type Gas strut / gas spring / lift support Pinhole-to-Pinhole Length Approx. 2.44" pinhole-to-pinhole / center-to-center Stroke Approx. 8.5" Rod Diameter 8 mm Force / Pressure 85 lb Material / Finish Black nitride shaft Quantity Included 1 gas strut Fitment / Application Category Details System Type Gas spring lift-support applications Primary Fit Replacement for applications using a 244-85 gas strut with matching pinhole-to-pinhole length, stroke, force, rod diameter, and mounting ends Common Uses Trailer, RV, camper, hatch, lid, compartment door, trunk, and prop-rod style lift-support applications where specifications match Fitment Method Match your original gas strut by part number, length, stroke, force rating, rod diameter, compressed length, and end fitting style Important Note Gas springs are application-sensitive. Verify measurements and end mounting style before installation. Top Features Feature Buyer Benefit Single Strut Listing Useful for replacing one matching gas strut where only a single lift support is needed 244-85 Size Reference Helps buyers match common gas-strut numbering and replacement markings 85 lb Force Rating Designed for lift-support applications requiring an 85 lb pressure rating Approx. 8.5" Stroke Supports correct travel-range matching against the original strut 8 mm Rod Diameter Provides a clear measurement point for replacement matching Black Nitride Shaft Matches black nitride gas spring applications where this finish is required Overview This listing is for one LaVanture LGP8-244-85 gas strut, commonly referenced as a 244-85 gas spring. This strut is used as a replacement lift support where the original gas spring matches the approx. 2.44" pinhole-to-pinhole length, approx. 8.5" stroke, 8 mm rod diameter, 85 lb force rating, and compatible end fittings. R&P Service Insight Gas struts should be matched by measurement and pressure, not by appearance alone. A strut with the wrong length or force can keep a lid from closing, fail to hold it open, or place excess stress on the mounting points. Measure Pinhole-to-Pinhole: Measure from pinhole to pinhole or center-to-center on the original strut. Match Pressure: Replace with the same 85 lb force rating unless the application has been specifically engineered for a different pressure. Check Both Ends: Confirm ball sockets, eyelets, brackets, and mounting hardware match your original setup. R&P Knowledge Hub Compatibility: This gas strut is intended for exact-replacement style applications where the part number and measurements match. Verify before ordering. Vehicle / System Fit: Suitable for compatible trailer, RV, camper, hatch, lid, compartment door, trunk, and lift-support applications that require the listed measurements and force rating. Installation Notes: Support the door, lid, hatch, or panel before removing the old gas strut. Gas springs are pressurized and should not be opened, cut, heated, or modified. Performance Insight: The 85 lb rating is the force output of this strut. Using a lower rating may not hold the panel open, while a higher rating may make the panel difficult to close or overload the mounting points. Brand & Fitment Note Selling Brand: LaVanture Application Reference: Trailer, RV, camper, vehicle, hatch, trunk, and compartment references are fitment categories only. They are not a guarantee of fit without measurement confirmation. What This Means: This listing is for one LaVanture gas strut / gas spring, not a guaranteed vehicle-specific OEM replacement unless your original strut number and measurements match. Before Ordering: Verify pinhole-to-pinhole length, compressed length, stroke, force rating, rod diameter, end fittings, mounting brackets, and quantity needed before installation. R&P Repair Insight When replacing gas struts, inspect both the gas spring and the hardware around it. Weak lift support may come from a worn strut, but damaged brackets, loose ball studs, or binding hinges can also affect performance. Replace in Pairs When Applicable: If your application uses two gas struts, replacing both sides at the same time helps keep lift force even. This listing includes one strut. Inspect Mounting Points: Check ball studs, brackets, screws, and hinges for looseness, wear, or bending before installing the new strut. Confirm Travel Range: Make sure the approx. 8.5" stroke matches the required opening travel so the strut is not overextended or bottomed out. Features One LaVanture 244-85 Gas Spring One replacement gas strut for applications requiring the 244-85 size and pressure reference. Approx. 2.44" Pinhole-to-Pinhole Length Designed for applications matching an approx. 2.44" pinhole-to-pinhole / center-to-center measurement. Approx. 8.5" Stroke Provides the travel range needed for compatible lift-support applications when matched to the original strut. 85 lb Force Rating Matches applications requiring an 85 lb pressure rating for lift assist and hold-open support. 8 mm Rod Diameter Clear replacement measurement for buyers comparing the rod diameter of the original gas spring. Black Nitride Shaft Black nitride finish for applications requiring this gas spring style and appearance. Included Components Quantity Item 1 LaVanture LGP8-244-85 gas strut / gas spring Not Included Mounting brackets, ball studs, screws, clips, or other hardware unless specifically shown or stated separately Important Fitment Note: Verify the printed part number, approx. 2.44" pinhole-to-pinhole length, approx. 8.5" stroke, compressed length, 8 mm rod diameter, 85 lb force rating, and end fitting style before ordering. Gas springs are pressurized components and should not be opened, altered, heated, punctured, or used as universal design components without proper engineering verification. Shop Gas Struts & Lift Supports Match your original gas spring by part number, length, stroke, pressure rating, rod diameter, and end fittings before ordering. LaVanture LGP8-244-85 gas strut, LaVanture 244-85 gas spring, LaVanture 244-85 lift support, 2.44 inch pinhole to pinhole gas strut, 8.5 inch stroke gas spring, 85 lb gas spring, 8mm rod gas strut, black nitride shaft gas spring, trailer gas strut, RV gas spring, camper hatch lift support, compartment door gas strut, trunk prop rod gas spring, replacement gas spring 244-85