Holden Rodeo TF 4ZE1 Pod Filter Adapter – 4 Inch Intake MAF Adapter

Holden Rodeo TF 4ZE1 Pod Filter Adapter – 4 Inch Intake MAF Adapter Upgrade the intake setup on your Holden Rodeo with this pod filter adapter, designed to fit where the stock air intake connects to the MAF sensor tube. This adapter allows installation of a 4 inch / 101 mm pod filter while keeping the factory MAF sensor tube layout. This part was designed and tested for a 1995 Holden Rodeo TF with the Isuzu 4ZE1 engine. Fitment with other Rodeo or Isuzu 4ZE1 applications may be possible, but is not guaranteed. ⭐ Features Designed for Holden Rodeo TF with 4ZE1 engine Adapts the factory MAF sensor tube to a 4 inch pod filter Suitable for 101 mm pod filter inlet size Designed to bolt where the original air intake connects Allows custom pod filter intake setup Two small auxiliary ports are included but blocked by default Strong and rigid construction Designed for engine bay use 🔧 Fitment & Installation Main compatibility: 1995 Holden Rodeo TF Isuzu 4ZE1 engine Tested application: Australian delivered Holden Rodeo with 4ZE1 engine Possible but unconfirmed compatibility: Other Holden Rodeo models from the same era using the 4ZE1 engine Some Isuzu vehicles using the 4ZE1 engine Possible Isuzu Trooper applications from the same era Important fitment note: This adapter was tested on a 1995 Holden Rodeo TF with 4ZE1 engine only Fitment with other engines, years, or markets is not guaranteed Please compare your MAF sensor tube, bolt pattern, and available engine bay space before ordering This is not a complete intake kit Pod filter, MAF sensor, clamps, hoses, screws, and other hardware are not included unless specifically stated Filter compatibility: Designed for a 4 inch / 101 mm pod filter Example style: 4 inch pod filter with rubber neck Sensor / port notes: The two smaller ports on the adapter are blocked by default These ports are intended as possible locations for an air intake temperature sensor and vacuum line if needed Opening or modifying these ports is the responsibility of the installer MAF mounting notes: The adapter is designed to fit where the stock intake bolts to the MAF sensor tube Original mounting screws may be used Hole alignment may not be perfect on every vehicle, so minor fitting or adjustment may be required Installation notes: Remove the factory intake section as required Test fit the adapter to the MAF sensor tube before final installation Install the pod filter onto the 4 inch adapter side Check all clamps and connections before starting the engine Installation should be carried out by someone who understands intake fitting and engine bay clearance 🖨 Material & Print Quality Printed in ASA only Heat-resistant – suitable for engine bay use Strong and rigid construction Designed for custom automotive intake use This is a 3D-printed part. Minor layer lines or surface marks may be visible. 📦 Included 1× Pod Filter MAF Intake Adapter Printed adapter only