Model Y Juniper Fog Light Trim Front Bumper Air Vent Trim Covers & Rear Taillight Side Trim Overlay

【Custom Fit】EVBASE front bumper air vent trim vovers and rear taillight side trim fit the 2025.03+ Tesla Model Y Juniper Premium. Molded from vehicle scans, each piece follows the original bumper curves for a close fit and even spacing along the edges. 【Coordinated Front and Rear Styling】The front canards mount beside the lower bumper air channels, while the rear trim follows the outer bumper sections below the taillights. Together, they add sharper lines and give both ends of your Model Y Juniper a consistent, sportier appearance. 【Two Finish Options】Choose gloss black for a clean look that matches the factory black trim, or a Matte Black for a more pronounced sporty style. Both options feature a smooth, glossy finish that stands out against the body color. 【Durable ABS Construction】EVBASE bumper trim uses lightweight ABS with impact resistance for everyday use. The material resists cracking, while the weather-resistant finish helps protect against rain, road grime, UV exposure, fading, and yellowing. 【Added Surface Protection】The trim covers selected areas of the bumper, helping reduce direct contact from light scuffs and minor scrapes. It adds a layer of protection over the covered paintwork while updating the vehicle's appearance. 【Clearance for Factory Sensors】EVBASE bumper trim follows the surrounding bodywork while leaving factory sensor openings clear where equipped. Correct placement keeps the pieces away from those openings so they do not obstruct the sensors. 【Lightweight Styling Upgrade】The slim ABS pieces add very little weight and keep the original bumper assembly in place. Their tapered shapes create an airflow-inspired look, with the focus on exterior styling rather than track-level aerodynamic performance. No-Drill Installation The pieces attach to the original bumper with 3M adhesive backing, with no drilling, cutting, or bumper replacement required. A cleaning kit and adhesion promoter are included to help prepare the mounting surfaces for DIY installation. Sharper Front Corners The front canards follow the lower edge of the bumper's side air channels, extending into a narrow, tapered point. It adds a more sleek outline around each opening and emphasizes the front bumper's width when viewed from the front. A Stronger Side Profile From a three-quarter view, the horizontal front canards and upright rear trim frame opposite ends of the vehicle. The different shapes work with the Model Y Juniper's existing body lines, giving the front a wider appearance and the rear a more defined outline. FAQs Q1: How can I give my Model Y Juniper a sportier look without replacing the bumpers?+ A1: This set adds front bumper canards and rear bumper trim to sharpen the factory body lines. The pieces attach directly to the existing bumpers, giving both ends a sportier appearance without a full body kit. Q2: Will the adhesive damage my paint or leave a sticky mess if I remove the pieces?+ A2: The pieces attach with 3M adhesive backing, so no drilling is needed. For removal, gently warm the adhesive and slowly peel the pieces away. Careful removal helps protect intact factory paint, though some adhesive residue may need to be cleaned off. Q3: Will these stay on at highway speeds or in heavy rain?+ A3: The molded shape follows the bumper contours, while water-resistant adhesive helps hold the pieces securely. Proper surface preparation is essential: clean and dry the mounting areas, warm the adhesive as instructed, and allow it to fully bond before driving or exposing it to water. Q4: Will these cover any sensors or affect parking assistance?+ A4: The pieces fit around the factory sensor locations, leaving the sensors unobstructed where equipped. When correctly positioned, they do not block the sensors used for parking assistance.