STM32F103C8T6 Blue Pill Programming & Serial Debug Kit

Learn firmware upload and serial troubleshooting with the STM32F103C8T6 Blue Pill Programming & Serial Debug Kit. The pre-soldered Blue Pill is paired with an ST-LINK V2 for SWD programming and debugging, plus a separate CP2102 USB-to-TTL UART adapter for serial messages and console communication. A 400-point solderless breadboard and 10cm jumper set support your connections. Use 3.3V signal levels, a common ground and one board power source, keeping the adapters' power outputs separate. A computer, development software and your own firmware are required to configure the project.Bundle value: Purchased separately, the included component variants total $32.71. This kit is $26.99, saving $5.72. 1 × pre-soldered STM32F103C8T6 Blue Pill board 1 × ST-LINK V2 programmer/debugger 1 × 6-pin CP2102 USB-to-TTL UART adapter 1 × 400-point solderless breadboard 1 × 120-piece, 10cm jumper wire set: male–male, male–female and female–female A computer, development software and your own firmware are required. Use 3.3V signal levels, a common ground and one board power source; do not connect the adapters’ power outputs together. Any additional USB cables, host adapters or external power source are not included.Read the kit setup guide for assembly planning, required extras and component references.